Thank you very much. Now I understand more about heating system. I have still cold air in rear but hear all time some knocking ( flap stuck probably ) I'll be back after checking few things.
I order it.
Good idea, I can close valve and check how engine works. If overheating disaper it means that maybe vavum selenoid stuck... and my theory was good, but ow is middle of the night here and I will check it tomorrow. If I need to replace SV haven't idea how remove it without disasembly...
Hi here :)
Yes, I have Fluke and can check it.
Yes, as you remember I have in car Superchips F5 Flashpaq with gauges but have few more and FordSys too. Live data shows something like this : the same like gauge on dashboard
https://www.youtube.com/watch?v=ivKqsGsIWRk&ab_channel=eMCZe
I...
One reason more why in my opinion it is not a head gasket. Today was warmer, about 55 F. I started and completely cooled down engine few times. All time without overheating. The engine temperature gauge showed 3/4 and after few second dropped to half. Now is much colder and after start engine...
This one :
??
hmmmm... 3 years ago I removed intake because had some false air, if I know....
EDIT: I remeber that I had one or two times fault from this sensor on OBD tester. I thought sensor fault was because of overheating not overheating because of sensor fault.
One week ago I changed all spark plug. I did it because I was doing borescopy of the cylinders, it was dry everywhere. Engine runs smooth at start, stable on idle. I drove with computer connected to the ECU. No missfire. I checked exhaust, both pipe without smell of coolant, without humidity and...
Hi,
I have the same problem. Overheating. I checked:
- exhaust gas in coolant - tested few times with bleu test ( no exhaust gas in cooling system )
- changed thermostat ( two times, now I have 165F )
- changed water pump ( old was in good condition )
- changed visco clutch
- changed heater...
You need to find "dark green/yellow" wire. It is wire from relay to the Inertia Fuel Shut off switch and from switch to the pump.
Because on junction box you have "few" wires and is not to easy located "dark green/yellow" one, the simpliest way to check fuel pump is use "Inertia Fuel Shut off...
You can check it with engine off and broken relay.
You need to bypass battery + with power supply for fuel pump. Now I don't have electric diagram but try to find.
I use 30 amp relay because it is standard car relay ( normal size ).
My fuel pump workf fine. Power consumption is lower than 20A.
I wrote you why I think that it can be fuel pump... but first need to check current for pump, and soldering new relay on PCB.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.