-
-
Nnabil replied to the thread Sudden death.Did the voltage drop test but all were healthy. Unplugged the maf, but also nothing changed. Forscan sees spark, fuel injecting, healthy...
-
Nnabil replied to the thread Sudden death.Well do that. Thanks!
-
Nnabil replied to the thread Sudden death.Update: I solved the shorting PSP and OPS wiring and renewed the entire harness branch. Now the truck always starts but dies...
-
Nnabil replied to the thread Sudden death.Thanks for asking. I sent it to an electrician eventually after running out of tests. He found the PSP switch wiring to be causing a...
-
-
Nnabil replied to the thread It’s making me crazy codes after diagnosis advance trac.Maybe, but also have to check the wiring, maybe there's an open or a short. Or the sensors you picked up have an issue.
-
Nnabil replied to the thread It’s making me crazy codes after diagnosis advance trac.You're welcome! In this case the best option is to just replace the sensor and hope the fault disappears.
-
Nnabil replied to the thread It’s making me crazy codes after diagnosis advance trac.For that C1281 code, you have to check the ABS module's main connectors for any corrosion or dirt, and also check the yaw rate sensor's...
-
NIf you have forscan, that'd be my next step to see if it at least sees the network and would tell you if your pcm is talking at all...
-
NThere are three plugs on the pcm, the transmission harness is the small one. It has all the transmission connections and the two rear...
-
NWas driving on a main street when I hit the brakes for an oncoming speed bump. Car was driving completely fine with zero issues...
-
NThey do not make any noise between 2wd and A4wd. Only the hubs engage and the electric clutch is active as needed. 4wh is a noise...
-
NYep, the A4WD setting simply energizes the coil which engages the clutches at whatever rate it's commanded. The minimum rate of...
-
Nnabil replied to the thread Loosing VSS signal causing speedometer non-op and shifting issues.Not the same gen, but I had a speedo that played around randomly and a flashing O/D off light (trans in limp mode) after a rebuild. I...
-
Nnabil replied to the thread Where are you from?.Nabil Azar, from Irbid, Jordan.
-
Nnabil replied to the thread Cold Water Leak.Since the leak stops when hot, I'd assume that's because of expansion, so the most appropriate candidates would be rubber seals or...
-
-
Loading…
-
Loading…
