Recent content by TxCamper9
-
Replacing Body Mounts
Body mount replacement requires many small 2x4s and other lumber that you can place between the frame and the body when you jack up the body. Replacing the mounts and bolts is a great way to bring back that new car feel to the drive. Just be careful and take it slow. An extra set of hands is...- TxCamper9
- Post #5
- Forum: 3rd Gen Ford Expedition Exterior
-
Rear Drive Shaft Rattle
I had an issue with the carrier bearing, in the middle of the rear drive shaft. When it goes out it does make noise.- TxCamper9
- Post #5
- Forum: 3rd Gen Ford Expedition General Discussion
-
2008 Exp XLT wiring harness
I would love to find a mechanic that could troubleshoot the harness/PCM issue here in Houston.- TxCamper9
- Post #10
- Forum: 3rd Gen Ford Expedition Electrical
-
2008 Exp XLT wiring harness
I'm about to get it towed back home, at least it won't be sitting at the dealer in the sun waiting 6 months for parts. I don't want the new tires and battery, paint etc to be damaged by it just sitting outside. I'm really fed up with the entire issue. I had to buy the wife another vehicle...- TxCamper9
- Post #8
- Forum: 3rd Gen Ford Expedition Electrical
-
2008 Exp XLT wiring harness
I had checked the fuel cut off switch when I did the job, I wish that would have been the issue. I have fuel, just no spark. Two prior mechanics looked at it prior to the Ford dealer. All have said the same, harness or computer. The current tech believes the harness may have shorted and...- TxCamper9
- Post #7
- Forum: 3rd Gen Ford Expedition Electrical
-
2008 Exp XLT wiring harness
After doing a complete timing job and putting the vehicle back together it would not start. Had a Ford tech stop by the house and he checked it out saying most likely wiring harness or PCM. The engine only turned and did not start. No codes. Towed it to a local shop and they had it for a...- TxCamper9
- Post #3
- Forum: 3rd Gen Ford Expedition Electrical
-
2008 Exp XLT wiring harness
I'm having trouble locating an engine wiring harness for my 2008 Expedition XLT. The dealer said it would take 6 months to get one. They said due to covid many of their suppliers went out of business when they were shut down by their state. The harness was the issue I was most worried about on...- TxCamper9
- Thread
- Replies: 9
- Forum: 3rd Gen Ford Expedition Electrical
-
2007 ford expedition body mounts
I have also been searching for the body mounts for awhile. I replaced them on my 2006 F350 with the polyuethane ones made by energy suspension and they worked great. It stinks that thay don't make them for the older Expeditions.- TxCamper9
- Post #4
- Forum: 3rd Gen Ford Expedition Exterior