Search results
-
Missfire on cyl 4 - now on 3 & 7, no power
Thank you! Will give this a shot and feed back.- Bratwurst
- Post #10
- Forum: 1st Gen - 1997 - 2002
-
Missfire on cyl 4 - now on 3 & 7, no power
Any advice, guys? Problem still persistent, startup is awful but runs fine when the weather is dry. Engine light is still on with same error. Thank you- Bratwurst
- Post #8
- Forum: 1st Gen - 1997 - 2002
-
Missfire on cyl 4 - now on 3 & 7, no power
Hello again, it has been an eventful 2 weeks - we have taken everything apart again and checked wires and the (new) spark plugs again. The engine was running fine and the shaking stopped. No more misfire error codes. During the test drive, a new error code showed up, P0118, which indicates ECT...- Bratwurst
- Post #7
- Forum: 1st Gen - 1997 - 2002
-
Missfire on cyl 4 - now on 3 & 7, no power
Thanks for your reply, 1955moose. So I guess I will go ahead and buy new spark plugs then. The way it looks now, I think that both coils were actually fine and didn't need replacement. Is there anything else you can think of that might cause these problems?- Bratwurst
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
Missfire on cyl 4 - now on 3 & 7, no power
Hehe thanks for the reply. I have not done any work on there myself, I admit being not talented enough. I am living in the Philippines currently and it's extremely difficult to find someone half-trustworthy here, who also knows what they are doing, I went with a repair shop that looked ok-ish...- Bratwurst
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
Missfire on cyl 4 - now on 3 & 7, no power
Hello guys, newbie here, and I hope someone is able to help with my engine problem. 97' Expi 4x4, 4.6L with the 2 ignition coils at the front of the engine It all started with the check engine light and the engine not running smoothly, no power. Diagnosis was misfire on cylinder 4, I then...- Bratwurst
- Thread
- Replies: 9
- Forum: 1st Gen - 1997 - 2002
