Search results
-
S
No pedal after start up, pedal if vacuum hose off and plugged from the brake booster
We replaced module got wrong vin and reprogrammed it. Nothing was wrong with original apparently either. We ended up finding out rear caliper we replaced was the wrong part. Replaced that bled brakes...no air. Test drive heard a noise saw a huge gouge in rim. Front pads were shot and wore funny...- Swaync11
- Post #5
- Forum: 2nd Gen - 2003 - 2006
-
S
2004 EB 5.4 Stalling when cold P0320 & P0351-P0358 Can't find the short
https://charm.li/Ford%20Truck/2004/Expedition%202WD%20V8-4.6L%20SOHC%20VIN%20W/Repair%20and%20Diagnosis/Powertrain%20Management/Computers%20and%20Control%20Systems/Testing%20and%20Inspection/Pinpoint%20Tests/Tests%20NC%3A%20Ignition%20Engine%20Speed%20Input%20Circuit/ This is for an 04...- Swaync11
- Post #26
- Forum: 2nd Gen - 2003 - 2006
-
S
abs module bleed
2004 Ford Expedition 2x4 4.6 Eddie Bauer, Soft brake pedal and have replaced master cylinder, brake booster, brake lines, abs module (re-programmed with forscan after b2900 code), we have done a manual bleed several times and after every new part, i attempted the abs module bleed with forscan... -
S
Brake problem in 2004 expedition
I just wanted to say that on my 2004 Expedition it doesn't have drum brakes. Don't you have to have drum brakes to have a wheel cylinder? I am experiencing the same problem currently. We have replaced everything from the caliper, master cylinder, brake booster and abs module, all brake lines and...- Swaync11
- Post #10
- Forum: 2nd Gen - 2003 - 2006
-
S
No pedal after start up, pedal if vacuum hose off and plugged from the brake booster
**Update, as of right now...i am not getting the B2900 code anymore!! I reset all of the dtcs, instead of just clearing the log originally. I do not have the P0401 code at the moment, but i have not been able to drive the vehicle to run the cycle for the egr for it to throw the code again...- Swaync11
- Post #3
- Forum: 2nd Gen - 2003 - 2006
-
S
No pedal after start up, pedal if vacuum hose off and plugged from the brake booster
also last year we dealt with the same code...p0401 and we replaced egr, sensor, 2 vacuum lines with a hole in it, (any part dealing with egr lol)then i took off and cleaned all the carbon build up on the throttle body and finally cleared the code to pass inspection....- Swaync11
- Post #2
- Forum: 2nd Gen - 2003 - 2006
-
S
No pedal after start up, pedal if vacuum hose off and plugged from the brake booster
Hello, I have a 2004 ford expedition 4.6 2x4 with no traction control. Last year we put new brake lines on because they were so rusted we had a leak. This year all of a sudden we were going through brake pads in the rear driver side so we put on a new caliper. Started it up and the brake pedal...- Swaync11
- Thread
- Replies: 4
- Forum: 2nd Gen - 2003 - 2006
