S20Workstation4
Latest activity Postings About
-
-
S20Workstation4 replied to the thread '05- Can't Siphon Gas?.If I remember right, there is a mesh screen in the bottom of the filler neck. It's to prevent people from stealing gas... Maybe use a... -
Good idea. I will check the bolts on the manifold. My wife's vehicle had something similar happen. If that doesn't take care of it, I'll...
-
S20Workstation4 replied to the thread Battery.Leaving the doors and tailgate open should be fine, the lights will usually turn off by themselves after 10 minutes Unless if you have...
-
S20Workstation4 replied to the thread 2012 Epxy - Start Up.Even though the exhaust manifold may not be cracked, it can be a broken manifold stud. Broken studs are more common on the 5.4 than...
-
Joe, thanks for the reply. I’d tend to agree with sensor issue. I’m trying to see the correlation between front AC and Rear. The rear...
-
Joe, There was a handful of fuses that I believe were related to the actuators. They’re the small microfuses and didn’t have anything...
-
S20Workstation4 replied to the thread A/C Blend Door or Sensor?.You're welcome, I'm glad both A/C Units are working again! I assume that since your reply, the A/C is still in good working order. How...
-
S20Workstation4 replied to the thread What to look out for 2018-2020 Platinum.The 10R80 Transmission in those years have Valve body issues and CDF Drum issues. They can bit hit or miss, some vehicles need a full...
-
S20Workstation4 replied to the thread 5.4, 3 valve Engine Tick.If the tick goes away within 1 minute, it is the exhaust manifold causing the noise. The broken-stud manifold is noisy on startup...
-
S20Workstation4 replied to the thread 2021 FX4 Tranny problems STILL after CDF fix.First thing I would try is to reset the Transmission adaptive learning. If that doesn't work, I would take it back to the dealer, show...
-
S20Workstation4 replied to the thread 2017 3.5L No crank after battery being removed.Are there any PATS system warning's (or an Anti-Theft Flashing Light?) It could be Anti-Theft problem preventing the vehicle from...
-
S20Workstation4 replied to the thread 2024 AC blowing cool not cold.I haven't experienced this issue before, but I would stick a thermometer in the front vents, and check the temperature of the air coming...
-
S20Workstation4 replied to the thread 2003 Ford Expedition -Eddie Bauer edition.I'm not sure about the cost, but just guessing here, probably no more than $100... I bought my own A/C Gauge set from Amazon for when i...
-
S20Workstation4 reacted to ExpyOnly's post in the thread 2008 Expedition XLT clunking when accelerating and slowing down. with
Like.
It was the rear passenger cv axle. https://www.tiktok.com/t/ZTNsXEEBR/ this is the video link. I used tiktok because it’s easy to make. -
S20Workstation4 replied to the thread 2003 Ford Expedition -Eddie Bauer edition.Sounds like the blend door actuator is becoming faulty. Once the temperature is set, it shouldn't change at all. Before actuator...
-
-
Loading…
-
Loading…
