Wangle
Full Access Members
Sorry, no, I did not have any clearance issues. I might have to get back under there and take a look to make sure I have clearance. Glad my write up was helpful!
10R80 Fluid Change Project Creep, New PPE pan.
- Thread starter Wangle
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
TheDoug
Full Access Members
I just purchased the PPE pan and was going to tackle the project myself as well.
Just to confirm, the raising of transmission is 100 percent necessary to to fit things?
Thanks for the info.
bshowalter
Member
Yes, at least on my 2019, 100% need to raise the transmission to fit this pan in.
And as a follow up, no issues so far. I haven't noticed the harsh P->R shift since but I don't drive it very much. The transmission temp seems much cooler now as well, rarely see 200*.
TheDoug
Full Access Members
Thank you!
TheDoug
Full Access Members
For those who did this in your garage... What did you use to jack up trans when getting new pan in?
Last edited:
Boosted
Well-Known Member
This is what I want to know too. Any input guys?
TheDoug
Full Access Members
bshowalter
Member
I just used floor jack with a block of wood on it. It doesn't take much force and you only need to raise it an inch or 2.
Shotgun76
Full Access Members
Any feedback on the PPE pan for those that be installed it? Thinking of doing same! Thanks!
Bmac1955
Full Access Members
My thought on this pan is probably good idea. Although if you drive it like one stole it........may be a bad for the components in the internals. Inspections of cooling lines and fluid levels are mindful to minimize overheating Trans. Just my thoughts on this.
Similar threads
