Recent content by John Sharp
-
J
Brake light sensor
I have tried rotating it and it doesn't want to move either direction... do you know which way it should rotate?- John Sharp
- Post #3
- Forum: 3rd Gen - 2007 - 2017
-
J
Brake light sensor
I just replaced the brake booster to get rid of my soft pedal and constant vaccuum leak. While I was under the dash I thought I had to have to remove the brake position switch (presumably) on the brake pedal to access the pedal pin. Well, I get everything back together and now my brake lights...- John Sharp
- Thread
- Replies: 5
- Forum: 3rd Gen - 2007 - 2017
-
J
RCM location
Thank you... you don't know where i could find a labeled diagram of the engine main harness do you? I have 3 connectors without connections and everything seems to work correctly- John Sharp
- Post #3
- Forum: 3rd Gen - 2007 - 2017
-
J
RCM location
Time to finish up this rebuild... does anyone know exactly where it is located? I have read both under the console and behind rhe radio. Also, is a simple replacement or does it have to be dealer flashed? Here is a little before and after- John Sharp
- Thread
- Replies: 2
- Forum: 3rd Gen - 2007 - 2017
-
J
Where is the Transmission Control Module
Where is the connector that plugs into the wiring harness? If one of the "extra" ends goes to the module, it should be somewhere on the passenger side, near the front...- John Sharp
- Post #3
- Forum: 3rd Gen - 2007 - 2017
-
J
Where is the Transmission Control Module
I have had to replaced the main harness in a crashed 2011 Expedition. I have a couple connectors left which I can not, for the life of me, locate connectors for. I am trying to track down 2 fault codes: U0114 - Lost communication with 4-wheel drive Clutch Module (I think this is the TCM...- John Sharp
- Thread
- Replies: 2
- Forum: 3rd Gen - 2007 - 2017
-
J
Engine bay wiring harness
I tried and I guess they don't have a repair pigtail for the ABS module. It is either buy the whole harness (12A581) for ~$1,000 bucks or find a junked car and cut and splice (or re-pin) the connector on. You can never find an intact engine harness junked- John Sharp
- Post #3
- Forum: 3rd Gen - 2007 - 2017
-
J
Engine bay wiring harness
So I am working on a 2011 Expedition and the ABS module and connector are damaged/missing. I have sourced the pump and module, but am having trouble with the wiring. I have looked througj fordparts.com and can not find an ABS repair pigtail. I have attached a picture of the wiring that is...- John Sharp
- Thread
- Replies: 3
- Forum: 3rd Gen - 2007 - 2017
