my 2006 expedition is throwing a code of p0420 catalyst system changed plugs last year 1 injector on cylinder 2 as well as the coil on same cylinder. Do I need a new cat or just change o2 sensor to be able to pass smog?
It happened late night after work and I drove it to a friends house where it was fixed. I don't remember exactly what code number it says I'm going to scan it hopefully tomorrow and refresh my memory but i was going to change the sensor and see what happens before I spend $1,400 on a cat since...
I have a 2006 expedition 4wd Eddie Bauer, last year I had a misfire happen on cylinder 2 so I ended up having to change the spark plugs since it was at 145k miles. Also changed coil, and injector on cylinder as well as the o rings on the rest of the injectors and it ran great afterwards. My...
The rack & pinion is a remanufactured one from oreilly and I used Prestone power steering fluid in it. I also bought an oem one from pick n pull just in case this one goes bad soon or I decide to take that one apart and rebuild it with the inner shaft, tie rods etc.
Ok so I just installed the rack & pinion for the 2nd time in 2 weeks now, and it still makes the same noise!? I've been told it could possibly be the away bar bushings? any thoughts on this? Also I had the car aligned yesterday 5/22/17 everything is dead on straight but the car pulls to the...
Yeah, so far so good on the squeezing for now but we'll see if it returns. My expedition also pulls to the right and I did align it after the rack instal but I read online that depending on what fluid you use in the power steering, it can make the vehicle pull? Is there a certain brand or...
I sprayed them down with wd-40 and grease and it did help and went away but it comes and goes now it's the weirdest thing lol. All this feedback is greatly appreciated, I'm going to change the inner tie rods tomorrow morning and go from there if it's not them, I will be changing the rack and let...
I have done that as well as far as having someone shake the wheel unlocked and grabbed the inner tie rods, you can feel it moving back and forth it seem as if the tie rods themselves are bad, but it can also be the inner shaft they connect to. I changed the inner tie rods in the old rack because...
Yes I flushed old fluid out and also had to replace passenger side outer tie rod end I used 1 outer tie rod end from my old rack which is oem. Also it did come with new inner tie rods but as soon as the wheels were on the ground with the new rack installed, it started making the knocking noise...
I have a 2006 expedition 4wd and I recently changed the rack &a pinion as well as a few other parts on the vehicle. Here is my problem my old rack made clunking noises over every little bump, as soon as I put the new rack in, it started making the same noise. Is anyone else having this issue and...
i have a 2006 expedition and am wanting to know if there are stiffer rear coil springs I can install or if you can install air bags for towing? Any info is much appreciated!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.