Late update
Turned out that middle piece is a connector. I was able to twist off the band with pliers and with some force I got the hose off. I did end up using the screw hose clamps, since the band wasn't going back on. Thanks for your help stamp!
Sent from my iPhone using Tapatalk
Good idea! I'll give this a try on the weekend when I'm back in town. Dome lights were working for me a few months ago though. Don't know if that matters or not with what you're suggesting.
I could try to make sense of wiring diagrams if not too complicated.
Anyone know if there is a plug in the headliner that detects if the doors are ajar? I would hate to drop the headliner again and it be something else.
Sent from my iPhone using Tapatalk
Hi- the dome lights on my 03 4.6 aren't turning on when the front or rear passenger doors are opened. They come on with both driver side doors and lift gate though. Not sure what's causing it.
Some back story: I replaced the door ajar switched in both doors when I purchased the vehicle a few...
Thanks for the tip! I don't think I could fit the hose around the metal part though since its wider. The middle of the metal connector is what the retaining clip goes on, so I can't cut the outer part of the connector off.
After some searching, the complete hose from radiator to engine with...
Hi, I noticed my lower radiator hose is cracked where it connects from the connector to the engine when I was changing the oil the other day. I purchased the hose, but I'm not seeing how to remove the hose from the connector. I've attached a pic.
Does anyone know how to remove? I tried...
Since it looks like it's coming out of the weep hole, I'm just going to go ahead and replace the pump. Does anyone know how much coolant to put back in?
Sent from my HTC One using Tapatalk
I started getting some belt sqeaking the other day on the highway on my 03 4.6 EB. There was a bit of a burning smell when I got home. I left the car parked until I could take a look at it. When I checked it last night there was no coolant in the reservoir. As soon as I added some distilled...
No rear view mirrors at the pick n pull you can grab? A flathead on the mounting bracket and a small wack with a hammer should release it.
When I bought mine the mirror was sitting in the center console. I used 3M rearview mirror adhesive and it worked perfectly. Make sure to follow...
I saw it on Amazon for over $50 for 200ml.
Not sure of what a body shop will charge, but just getting the roof panel I think is over $500.
I actually just repaired one of the 6 grooves today. I used an angle grinder and cutoff the rusted area (about 4 inches around). I then put the 3M bondo...
Just the cable can be replaced. I did both rear windows recently that had the same problem. Remove the 3 screws from the motor and you can access the cables. I used needle nose pliers to remove the cables from the track pulleys on the top and bottom.
Cables should be just a few bucks at the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.