Recent content by Sam Odajima
-
S
I seriously messed up
2004 Expy 4.6L. I removed my intake manifold to replace some bad gaskets. I diagrammed which hoses went where but now I've misplaced my diagram (probably threw it away in a fit of rage when cleaning up the garage). Is there some sort of diagram available that shows which lines go into the back...- Sam Odajima
- Thread
- Replies: 1
- Forum: 2nd Gen - 2003 - 2006
-
S
Intake Manifold Insulator
2004 4.6l 162,100 miles. I'm replacing the intake manifold gaskets because of a slight leak. When I finally got to remove the intake I found broken plastic pieces. These came from the insulator box. The box crumbled when I removed it. My question is do I need this? What are alternatives to...- Sam Odajima
- Thread
- Replies: 1
- Forum: 2nd Gen - 2003 - 2006
-
S
AC Drain Tube
Is that the transmission dipstick tube in the second picture?- Sam Odajima
- Post #6
- Forum: 2nd Gen - 2003 - 2006
-
S
AC Drain Tube
What is the easiest way to clean/clear the tube?- Sam Odajima
- Post #4
- Forum: 2nd Gen - 2003 - 2006
-
S
AC Drain Tube
I have an 04 expedition 4.6L. I have a wet passenger floor board. I dont have a sun roof. I cant find/see the ac drain tube. Does anyone have pictures and some instructions on clearing. I did a search on the forum and I have seen posts that explain it but pictures are no longer available.- Sam Odajima
- Thread
- Replies: 8
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
The wiring diagram made all difference. Little yellow and blue wire was the problem.- Sam Odajima
- Post #19
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
Bench tested the starter. Starter engages and gear spins. When I attach the cables, The starter engages (gear pops out) but it doesnt spin- Sam Odajima
- Post #16
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
It wasnt overheating. I checked the oil for any signs of coolant and there wasnt any leak.- Sam Odajima
- Post #13
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
2004 4.6L. I replaced the PCM relay and it didnt make a difference. I checked ground wires but didnt do a voltage drop test. Thanks for the explanation of 87 and 30. I will see about that this evening.- Sam Odajima
- Post #11
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
I'm unclear on what you mean by 87 and 30 terminal?- Sam Odajima
- Post #5
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
Anti theft light is blinking normally. It doesn't flash when I try to start the car- Sam Odajima
- Post #4
- Forum: 2nd Gen - 2003 - 2006
-
S
No crank
I was working on an coolant leak in the emtal line that runs to the rear. Took it for a long drive and the line is fixed but when I went back out the best day my expy won't crank. So I had the battery checked and it registered as bad. So I replaced the battery and still no luck. So I cleaned...- Sam Odajima
- Thread
- Replies: 19
- Forum: 2nd Gen - 2003 - 2006
-
S
Heater AC Control
The valve appears to be working. If I zip tie it closed it stays cool. There is no noise like the blend door is trying to open or close.- Sam Odajima
- Post #7
- Forum: 2nd Gen - 2003 - 2006
