Recent content by sk8blind345
-
S
wheel hub assembly bkew apart
Yea that will. What I ended up doing until installing a switch that will cut power to the transfer case motor. I un plugged the harness at the transfer case and filled them with dielectric grease to keep it safe. But you can pull the #104 fuse in the engine bay that will disable your all wheal 4x4.- sk8blind345
- Post #7
- Forum: Suspension
-
S
Newbie Needs Help
#2 do you have low beams? If so it may be your turn signal switch its all one assembly. If you take off your cover on the steering colem so you can see the switch, testthe plugs while there plunged into the switch with a test light to see if your getting power out of the switch when you put on...- sk8blind345
- Post #6
- Forum: 2nd Gen - 2003 - 2006
-
S
wheel hub assembly bkew apart
Will that eliminate some of the drag from the front diff- sk8blind345
- Post #5
- Forum: Suspension
-
S
wheel hub assembly bkew apart
Well that would explained my issues then . well looks like I'll be doing wheel hubs than lol. Many I'll just take out the #104 fuse in the engen bay this time.- sk8blind345
- Post #3
- Forum: Suspension
-
S
wheel hub assembly bkew apart
So I thought I was gonna save some money on fuel an take out my front trans axels on my 2000Expodition an disable the a4x4 an made it about 5 miles and my front wheel al,most fell off... My boss from work (ford tech) said it be fine well aperently not. Dose anyone know if the half shaft is...- sk8blind345
- Thread
- Replies: 6
- Forum: Suspension
