Search results

  1. B

    info, reset, setup, anti-skid, flasher buttons not working

    This turns out to have been the issue. There are 2 connectors on the back side of the buttons. The connections on the back of the panel had been left unconnected. My wife had someone look at the stereo since it wasn't working properly and they did not hook these back in. It was a surprise to...
  2. B

    info, reset, setup, anti-skid, flasher buttons not working

    Agreed that they can look fine and still be bad. I checked the fuses for continuity with a DMM. Learned that long ago from the severe reaming I got as a young airman from a CMS after we spent too long out in the cold trying to troubleshoot an F-4. After we had been over the possibilities...
  3. B

    info, reset, setup, anti-skid, flasher buttons not working

    info, reset, setup, anti-skid, flasher buttons on the center dash not working. when you press any of the above buttons on the center console nothing happens. I unhooked the battery for about 10 minutes to try to reset the system. While the battery was disconnected, I looked for fuses that...
  4. B

    rear a/c actuator needs replacing

    Try this thread: http://www.expeditionforum.com/f40/adjusting-hvac-door-actuators-23979/ This may be the discussion you were referring to, but the link to the amazon part is dead http://www.expeditionforum.com/f40/c-clicking-noise-back-help-20026/
  5. B

    '08 Exped will not start

    For those interested, most of my search for the fuel pump itself centered on the Denso line of pumps. They have over 400 similar pump part numbers to the one that melted in the Expy, but none of them will match directly to the 2007-2008 Expys. I tried to get a match so I could be confident in...
  6. B

    '08 Exped will not start

    Fuel pump replaced and vehicle now running. Had the Expy running for about an hour and the motor sounds fine. I ran out of time looking for a replacement for the fuel pump itself and had to spring for the whole assembly to get the truck back on the road. I bought the Precision Fuel Pump from...
  7. B

    '08 Exped will not start

    The hose mentioned in my previous posts is just a vent to atmosphere. It ran up to the top of the fuel filler neck and was not connected to anything. So, tank is out. Pump is out of the tank and it is melted like others have mentioned. If I can get the part, it looks like it is just the...
  8. B

    '08 Exped will not start

    I do not see any type of disconnect on this line at the back of the tank. It runs under what looks like a protective shield for rocks and debris that is on the driveshaft side of the tank. Maybe I need to remove this shield? Here is a picture of the connection I am referring to on the fuel...
  9. B

    '08 Exped will not start

    I applied 12 VDC to the pump and got nothing. Worked at getting the fuel tank out to check the fuel pump. Have the tank out and on the ground with all connections to the tank removed, except for one ribbed, flexible vent tube that I cannot see how to disconnect from the tank. The view in the...
  10. B

    '08 Exped will not start

    Does the Expy have a FPDM? Unless I missed it, I do not see it listed in the Chilton or Haynes manual or on the wiring diagram. The parts listing on Rock Auto does not list a FPDM for this model either.
  11. B

    '08 Exped will not start

    Thank you guys for your help. Do you mean the inertial switch behind the rear drivers side interior panel? I have 12V to that for a moment when the truck is in the on/run position. As if the PCM turns it on then off - either as normal or the PCM has detected a fault then shuts it off.
  12. B

    '08 Exped will not start

    fuses checked, all fuses good.
  13. B

    '08 Exped will not start

    I checked the fuel rail pressure and found nothing there, so I didn't see if she would fire with cleaner figuring that the problem was no fuel. I need to figure out why no fuel pressure. I took out the fuel filter, which needs to be replaced anyway, and I get no fuel out of the pump when I...
  14. B

    '08 Exped will not start

    Reset the switch and still no joy.
  15. B

    '08 Exped will not start

    Checked fuel pressure at fuel rail. No pressure.
  16. B

    '08 Exped will not start

    With respect to the check engine light, I just tried it again to be sure and the CEL IS flashing 8 times after I crank the motor. Then the CEL stays illuminated.
  17. B

    '08 Exped will not start

    The Mrs' Exped left her stranded, it came home on a flatbed TT. She tells me at home that the Exped had been laboring a little bit to start for the past couple of weeks and it would not crank for her on the road after it died. sounds like a dead battery. took battery to auto zone for load...
  18. B

    Exped Service Manual

    I have seen those on ebay, too. About $65-75 for the set of 3 manuals shipping included.
  19. B

    new member in TX

    Hello everyone, Checking in from the North Dallas area. New to the Expy and to the forum. Just purchased an '08 XLT with 23K miles for the Mrs. to carry the family in. Hoping for many, many moons of trouble free driving. I spend most of my time showing love to my '03 Ram Hemi. The...
  20. B

    Build sheet

    agreed, but I am lazy and was hoping to be able to get it from my keyboard. :-) If I have to I would go in and get it.
  21. B

    Build sheet

    pm sent
  22. B

    Build sheet

    That does work for getting the window sticker. Thanks, Wes.
  23. B

    headphones

    I found these threads about headphones that might (?) help. http://www.expeditionforum.com/showthread.php?t=9576 http://www.expeditionforum.com/showthread.php?t=1665 http://www.expeditionforum.com/showthread.php?t=9256
  24. B

    headphones

    I need to get a set, too. So, I will have the same question in a bit. I have the stock set-up. Are you going to get stock headsets, Freeway?
  25. B

    OBD 2 scanner tool

    I have used the scan tool and software from these guys for years. http://www.myscantool.com/ Most of my experience with this tool has been on my Ram. The only drawback I can think of is that you cannot get to the other control module codes with this scanner like the air bag and ABS (but...

Latest posts

Members online

Total: 1,313 (members: 15, guests: 1,298)

Forum statistics

Threads
53,696
Posts
503,108
Members
47,344
Latest member
jmdunham2

Share this page

Top