Is there a way to test the relay? There is no clicking when switch is moved. Tested switch, It works. Pulled wire harness off shift motor. Light finally comes on in dash but still no click from relay. Put wire harness back on motor, No light and nothing. By the way finally found where the...
Do they work properly with aftermarket rims or just factory ? I put on a normal spacer but have wheel wobble at 35mph then its gone. The only thing I can think is my studs are a tad to long. I was going to trim the studs then see if the wobble is gone. Any ideas ?
Hey,
Is this a good deal for a 5.4l supercharger? Is there anything I should look for? Also Can I bolt this right on my 5.4l or do I need to change or do? Thanks!
Ford Supercharger for 5.4 L with upgrade pulley (2.8)
Asking $ 275.00
Because of the 3" body lift, I had to recess the bar brackets into my bumper. Doing so made the push bar look normal height. Angle grinder and sparks everywhere :)
Is there any way to remove white small pits off chrome rims? They don't look too bad but you can still see tiny dots. I am using 0000 steel wool and some turtle wax polish but just cant seem to clear it up. Thanks for any info!
Reef
Hello All,
I just replaced the wheel hub assembly with abs sensor. The dash abs light is on steady. Is there a way to reset this light? Im pretty sure there is no problem with abs. Thanks,
Reef
Is there a difference between bbk and jet pulleys? I need to replace them and thought of going this route. Thanks!
97-02 Ford Expedition Pulley Kits from BBK at Andy's Auto Sport
97-02 Ford Expedition Pulley Kits from Jet at Andy's Auto Sport
Hello All,
I have removed my factory fog lights and installed rigid industries led fog lights. I want to close up the hole around the lights. Does anyone know where to get the covers that came on bumpers without fogs? Or what can I make my own out of? I'm thinking wire mesh painted? Any...
I have a 98 4x4 5.4l EB. Is there a trick to get the first o2 sensor out? Its the one right on the exhaust manifold I believe. I can see it from the front wheel well. I have noticed my gas millage is going down and I believe it's the culprit. Also there is play in my tie rods on one side...
This was the best way for me to raise up my suspension up a little for a more aggressive look. I've since then put on a 3" body lift but used this method to level the front end.
In the front driver side wheel well behind the wheel is a sensor. I took it off the ball joint and zip tied it...
I have a 3 inch body lift. cranked torsion bars. Lifted it by adjusting the airbag sensor up just a tad. Cut front valance for room. Im running 33's on stock 17's. I know I can go 305 70 r17 (35) but I don't think it would be enough......lol Thanks
Hello all! I have been on here looking for months now. My truck is a 1998 eb with a 5.4l v8. Hypertech programmed. K&N cold air intake. Flowmaster exhaust. 3 inch body lift. torsion bar twist and raised the airbag sensor. Tires are 33's hankook dynopro MT on stock 17's.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.