Pinky 1352
Active Member
This is a 2003 Expedition XLT that needed it's rear heater core replaced.
Removing was easy enough once I found all of the screws, but getting the black cover BACK ON is stumping me!
Is there a trick to keep all of the components in place while trying to replace the cover?
Should the door actuators be removed or left in place?
I'm finding that either the AC core moves a slight bit, or the blend door over the heater core moves out of it's slot. Which makes getting the cover back on impossible.
I was at it for over an hour yesterday and finally had to walk away.
I've obviously searched for videos but haven't found any.
Any clues as to what technique I may be missing would be greatly appreciated!
Removing was easy enough once I found all of the screws, but getting the black cover BACK ON is stumping me!
Is there a trick to keep all of the components in place while trying to replace the cover?
Should the door actuators be removed or left in place?
I'm finding that either the AC core moves a slight bit, or the blend door over the heater core moves out of it's slot. Which makes getting the cover back on impossible.
I was at it for over an hour yesterday and finally had to walk away.
I've obviously searched for videos but haven't found any.
Any clues as to what technique I may be missing would be greatly appreciated!