Recent content by bocco
-
B
ABS question
About a month ago I put new brake pads on 2000. Since I'm real close to the 200K mile club I thought it might be a good idea to flush and bleed the brake fluid. I bought a pressure bleeder and all seemed to go well. I sucked the old fluid out of the master cylinder and pushed a lot of fluid...- bocco
- Thread
- Replies: 1
- Forum: 1st Gen - 1997 - 2002
-
B
2000 Expy charging voltage problems
Problem solved. For the benefit of anybody else with this problem. The 12V lead to the 3 pin connector is supposed to be hot all of the time even with the key off. It turns out that the 20amp fuse in the under hood junction box had a flaky connection and the 12V supply was intermittent. I just...- bocco
- Post #4
- Forum: Electrical
-
B
2000 Expy charging voltage problems
Thanks for the wiring diagram. That's perfect.- bocco
- Post #3
- Forum: Electrical
-
B
2000 Expy charging voltage problems
So two weeks ago my battery light comes on and my add on digital volt meter reads 12.2V. i was an hour away from home so I just turned every thing off and drove home. Double checked the voltage at the battery with a good meter and only read 12.1V so I assumed alternator and replaced it. Same...- bocco
- Thread
- Replies: 3
- Forum: Electrical
-
B
2000 Expy charging problems
Does anybody know where I might find a replacement for the alternator wiring harness? Looking all over and can't seem to find one.- bocco
- Post #4
- Forum: 1st Gen - 1997 - 2002
-
B
2000 Expy charging problems
I think I figured it out. There are two connectors to the alternator, one three pin and one single pin. I reseated the three pin connector and the problem appears to be solved.- bocco
- Post #2
- Forum: 1st Gen - 1997 - 2002
-
B
2000 Expy charging problems
Today the battery light came on in my 2000 Expedition. It showed low voltage at the battery when running so I assumed alternator and changed it. Still have the same problem. Starts and runs fine but only reads 12 volts at battery when running. Alternator field fuse is good and fusible link...- bocco
- Thread
- Replies: 5
- Forum: 1st Gen - 1997 - 2002
-
B
New Headlights!
So I have this tool and one other knob syle. There is just no room to move it in my 2000. -
B
Alarm System Recomendation
I just put a new Kenwood double DIN head unit and speakers in 2000 Expy. Had to modify the dash to fit it in. Now I'm wondering about an Alarm system. Way to many options to sort out so I'm looking for recommendations. Easy installation would be a big plus. Motion detector would be cool also...- bocco
- Thread
- Replies: 0
- Forum: Audio & Electronics
-
B
Door side molding.
So thinking about repainting my 2000. My door side molding look bad. The fake plastic chrome inserts are shot. I'm wondering if anybody has removed the chrome and just painted them with the rest of the truck and if so how does it come out? thanks Gary- bocco
- Thread
- Replies: 4
- Forum: 1st Gen - 1997 - 2002
-
B
seat covers for xlt front seats
Just finished both front seats on my 2000 last week. They look great. I added about 3/4" of foam to build up the bottom of the driver seat. It was about $800.00 to do both front seats but I love the results.- bocco
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
B
Odometer doesn't work after getting gas
Be sure to use flux. These flux pens work great. https://www.amazon.com/Kester-951-Soldering-Low-Solids-No-Clean/dp/B004X4KOWS/ref=sr_1_7?ie=UTF8&qid=1481472260&sr=8-7&keywords=flux+pen Don't use plumbing flux.- bocco
- Post #9
- Forum: 1st Gen - 1997 - 2002
-
B
Odometer doesn't work after getting gas
Raining all day yesterday and today in Northern Ca. Spent some time in the garage. Fixed the over head display and my odometer on my 2000 Expy. Thanks to all that posted pics and made the videos.- bocco
- Post #7
- Forum: 1st Gen - 1997 - 2002
-
B
Rear wiper failure
Thank you for this ^^^^. I feel kind of dumb but the job is done so I'm over it.- bocco
- Post #8
- Forum: 2nd Gen - 2003 - 2006
