Correct. As-built can be pulled from ford with a VIN, and is specific to the vehicle as it came off the line. I am adding aN oem trailer brake controller to my 2012 expy. It was not an option until 2013+, 2012 and back were aftermarket only. I wired in the oem tbc to the appropriate connections...
Anyone on here have an as built table for Gen 3 Expy's?
Or are they cross compatible with something else?
Specifically looking for as built IC on a vehicle (2013-2014) with OEM Trailer Brake Controller for comparison to mine.
Thanks.
2012 Expedition no TBC
ICM 720-01-01 9105 7DFF...
Any updates? I’ve wired a 2014 tbc into my 2012. See the tbc in forscan (only when I Tell it to use 2014 mykey). Made some adjustments to my IC as built and reset DTCs. No issues.. however, no gain control on dash. Trailer sway is listed, but I think the 2012 already had that. I’m not getting...
Mine came off of a 2014 expy that was wrecked with parts for sale on ebay. Junk yard, etc would be a place to look. If I can get this working, I'll do a writeup with part #s. My concern is finding the correct wiring harness connector (or splice), and reprogramming the computer to enable.
I recently purchased a 2014 Trailer brake controller used to install in my 2012 expy.
The 2012 has a 6 pin connector next to the ODB2 port used for attaching an aftermarket controller.
The 14 pin connector to attach the factory OEM above the console, below the cig lighter is no where to be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.