-
-
jr1under replied to the thread Door Ajar sensors.I've followed your saga for a long time so I'm interested in what they have to say too. -
jr1under replied to the thread Door Ajar sensors.Mine's a lot easier to ignore than that! After testing and experimenting for months, I still think the codes I'm getting are ghosts in...
-
My engine to body ground bolts in the back of passenger side head, comes straight up to the right of the starter solenoid on the...
-
jr1under replied to the thread Windshield resealing my 2000 xlt.Does the other end of that ground connect to the green stud next to the PCM? It'd be a nice find if that's what's going on!
-
-
Yes where they used double sided tape to direct water also under the cover.. I sealed it up with the Permitex windshield sealer and made...
-
jr1under replied to the thread Windshield resealing my 2000 xlt.Are you talking about the seam in this picture?
-
-
jr1under replied to the thread About to pick up a 2001-what should be done first?.That's fairly low mileage for a Gen1. If there's not much frame rust and no serious engine or transmission issues, it sounds like a...
-
Nice penny. A WWII vintage steel penny.
-
jr1under posted the thread Revealing pictures of an NSS in 1st Gen Ford Expedition Transmission & Drivetrain.If you've ever wondered(and who hasn't?) what a Neutral Safety Switch looks like on the inside, here's an example from my wife's 2005...
-
-
Beats me, I’m just going to bite the bullet when I pull the dash, every connector will be checked, and the Gem replaced.. I’m convinced...
-
jr1under replied to the thread PO500 story continues with new twist.Mine continues to have a 0.22A drain and Low Voltage code. The draw is split evenly between two circuits but I haven't isolated anything...
-
jr1under replied to the thread PO500 story continues with new twist.My interpretation of what grok and the OBD SysOp manual say: Unless the truck is moving, the VSS does not output a signal nor does the...
-
-
Got my transmission at least where it’s driving.. I’m now just getting the PO500 when I go to crank it only.. I can clear the codes...
-
jr1under replied to the thread 2001 4.6 2wd expedition what nut size wrench?.Don't have any wrenches that big but, as measured with my calipers and what grok says, it's 27mm.
-
jr1under replied to the thread Coil pack bolts 5.4.Hope this is not too late but here's a link to a vendor I've used before. I think the bolts are M5 x 0.8, 27mm length...
-
-
Loading…
-
Loading…
