-
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.I reset the PCM and drove the Exp about an hour, on city streets and on the highway. Drove really well, no unusual noises. Low Oil...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.Ah, fun stuff! Will do. One last question and I will stop imposing on your goodwill: the "High temp Low oil" light stays on even after...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.So I just confirmed that the oil pressure is still at 90PSI (I didn't even re-prime it) but the oil pressure gauge in the cluster is...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.I neglected to mention that I did test the oil pressure sensor wire to ground and there was no change in the gauge. This was before I...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.Things just keep getting weirder. I used this oil pressure test kit (thanks toHamfisted for the recommendation) and it worked great, I...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.Good to know. I may be going this route myself if the manual priming doesn't work out.
-
EEric M reacted to SafariGoneWrong's post in the thread 03 5.4L 2V - new oil pump won't prime with
Like.
I couldn’t get pressure by cranking the engine after installing a high volume Melling pump during a full timing job along with roller... -
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.Thanks for the diagram. I will resume testing when my new sender arrives tomorrow.
-
EWith the key in the RUN position and you ground the harness plug, do you get a normal oil pressure indication on the gauge ? The sender...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.I am in the process of checking the oil pressure sensor wires and the sensor itself. I have a couple of questions: 1. The sensor has...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.You are right about the wires. I did come into contact with them many times during the rebuild. I will need to inspect them more closely...
-
EEric M reacted to Vincent Vega's post in the thread 03 5.4L 2V - new oil pump won't prime with Like.
@Eric M This is just a thought but the oil sending wires may have gotten a beating as you were removing the LH valve cover, and then...
-
EI am getting ready to change my oil pump on my 4.6 Romeo as part of a timing job. I saw the same video you mentioned above and even...
-
EEric M reacted to Don Hall's post in the thread FOR THE 2003 & 2004.... IS THE FUEL PUMP RELAY UNSERVICABLE? with Like.
Received a reply from FUEL RELAY REPAIR SERVICE (ebay). Two prices: $67.99 only replace fuel pump relay. $126.99 replace fuel pump...
-
EEric M replied to the thread 03 5.4L 2V - new oil pump won't prime.Never any issue with oil pressure lights before rebuild. No codes are being thrown either. I just happened upon a video and it appears...
-
-
Loading…
-
Loading…
