Recent content by jfordtruckman
-
J
How is camber adjusted?
The upper control arms have a factory alignment key in them and to adjust caster or camber yes a bolt kit is needed. You can adjust the camber and caster with out the kit because where the control arm bolt in there are slots there however it is very very time consuming to try to push and pull...- jfordtruckman
- Post #2
- Forum: 1st Gen - 1997 - 2002
-
J
moaning noise in reverse
I have a 1997 ford exp and when I am backing up while turning i get a moaning sound coming from the front end. More recently I have now notice a grinding noise from the front end which sounds like brakes but is not. I also get a vibe when above 65mph and the faster I go the less noise until I...- jfordtruckman
- Thread
- Replies: 2
- Forum: Transmission & Drive train
-
J
2002 hesitates and shakes when cold...
there is a tbs on that issue ford has issued. Contact your local ford dealer to get the information. If no luck from then hit me up I have mitchell on demand.- jfordtruckman
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
J
front differential problems
I have a 1997 and when in reverse and turning the wheel I get a loud growling noise. Then when at speeds above 55 then letting off the accelerator I get a vibration and humming. Any ideas both wheel bearings are new. Also lf half shaft is new as wheel- jfordtruckman
- Thread
- Replies: 1
- Forum: Transmission & Drive train
-
J
Different tire size
I have the 17in package on mine and I put those tires on as well. God do I love them. By the way I run a tire shop and sell almost every tire on the market. I would go with the yokohama at's 275/70r16- jfordtruckman
- Post #10
- Forum: 1st Gen - 1997 - 2002
-
J
Towing lights not working
On my truck where the trailer harness runs over the fuel filler hose the wires were exposed and broken. They rubbed right through- jfordtruckman
- Post #9
- Forum: 1st Gen - 1997 - 2002
