Recent content by sinacle1

  1. sinacle1

    yet more 4 wheel drive problems

    I stated just above this reply that I have changed the switch motor and the problem continued. Anyhow traded the truck in with the problem still ongoing. I an a f250 owner now. Thanks for all the suggestions.
  2. sinacle1

    yet more 4 wheel drive problems

    Just replaced the transfer case switch motor. You have to pull out some pins and use the new plug, everything looked great at the plug when I did that.
  3. sinacle1

    yet more 4 wheel drive problems

    Played with it a little this morning and got it to go into 4 hi almost every time. Still won't go into 4 lo at all. Got under the truck and manually played with the front axle disconnect, when disengaged drive shafts spins freely, engaged doesn't. Guessing that works fine. I can hear it when I...
  4. sinacle1

    yet more 4 wheel drive problems

    Well its been a while, but I have changed the GEM out behind the fuse box and the selector switch on the dash. Still having the same problems. Any one else have any suggestions aside from cutting a hole in the floor and making a make shift linkage?
  5. sinacle1

    yet more 4 wheel drive problems

    Ok, The only relay I found was over the left side of the radio, under the big part of the dash trim that goes from the right side of the radio all the way to the drivers door. After unplugging and playing around with the relay I now have 4 hi but no 4 lo. Better than nothing, but I use (or use...
  6. sinacle1

    yet more 4 wheel drive problems

    Ok after more online searching it looks like what I want to check into is the relays that control the transfer case shift motor, and the GEM behind the fuse pane under the dash. apparently the relays are behind the radio. Does anyone have any experience with these relays? I'm not getting any...
  7. sinacle1

    yet more 4 wheel drive problems

    My 97 expedition is only going in 4 hi sometimes, after playing with it for an hour I got it in 4 hi maybe twice and in 4 lo once. Everywhere I look all I see is check vacuum lines, but I can't get the transfer case to switch. When I switch to a4wd I hear a faint click and the a4wd light comes...
  8. sinacle1

    Broke bolt for coil pack?

    I did the same to mine about 4 years ago. I wound up squishing 2, 1/2" or 3/4" hoses cut to about 1" lengths with zip ties holding them together and zip tied them to my fuel rail over top of my coil to hold it down. I keep telling myself I'm going to fix it, but after 4 years, a tune up, and new...
  9. sinacle1

    Sea Foam, did I do it right?

    yeah, I drove up to the store to add gas and sea foam in my tank.
  10. sinacle1

    Sea Foam, did I do it right?

    slowley poured the whole can in. The brake booster vac line does lead to all cylinders right?
  11. sinacle1

    Sea Foam, did I do it right?

    OK I just let it set for about ten min. started it up revved up a bit, got a little smoke, nothing like I expected. Took it around the block and romped on it a bit and still nothing.
  12. sinacle1

    Sea Foam, did I do it right?

    I just got done sea foaming my engine through the brake booster vacume line and I never saw any smoke from my exhaust, is that good or bad. I have a 97 EB with a 5.4 with about 150,000.
  13. sinacle1

    Air ride conversion

    My air ride just crapped out on me. So I disconnected everything, pumped up my rear air bags and cranked my torsion bars up. I didn't want to spend the money on the "air ride conversion" so I started doing some comparing. Parked next to an expo w/o air I couldn't really tell any differences that...
See more

Latest posts

Staff online

Members online

Total: 2,590 (members: 13, guests: 2,577)

Forum statistics

Threads
57,620
Posts
536,384
Members
54,673
Latest member
dakjholt

Share this page

Top