Recent content by suthern kumfert

  1. S

    99 4.6L windsor timing set

    any recommendation as to what brand to buy? I don't want to have to do this again for a very long time. also any tips or tricks if you have done this before?
  2. S

    99 4.6L windsor timing set

    I am guessing I have a tensioner or guide that has failed cause I am getting noise from the passenger side timing cover area. I have a few question that I hope you can help me with. First off is it ok to just replace the tensioners and guides and not the chain and sprockets? (don't have the...
  3. S

    nut sizes

    Ha! I will have to see about this DVD you are talking about
  4. S

    nut sizes

    Thanks I am going to do just that. I also have a drill I plan on using...
  5. S

    nut sizes

    I seen a video today that said tie rod and upper ball joint is a 13/16 and lower ball joint is a 1 1/16...I plan going to the auto part store and they said they will allow me to take the sockets outside and slide under my SUV and see if they fit. I am going back with all moog parts. I spent the...
  6. S

    nut sizes

    Thanks for replying. It is a 2 wheel drive. I read that the hub nut is a 35mm. Yes I have done a job like this before but just not on my expedition. Yes I do have the normal wrenches and sockets as well as the picked fork. I will also rent the ball joint press from autozone. I just don't want to...
  7. S

    nut sizes

    Thanks for the input. I found a website that says my hub nut is 35mm.
  8. S

    nut sizes

    hello to all, I have a 1999 expedtion xlt 2 wheel drive. i have almost 200,000 miles on it and i am going to replace the lower ball joints, inner and outer tie rod ens on both sides, the upper control arms on both sides, sway bar bushings, pitman arm and the idler arm as well. I only have the...
  9. S

    having to turn the key two or three times

    Ok...sounds like a plan...i am sending you a message now....thanks
  10. S

    having to turn the key two or three times

    Thanks for the quick response. it has 173,000 miles and as far as i know yes it is the original starter. as far as wiring i do understand wiring diagrams. i have a hanes manual will that have what you need? i did look at the wires and they seem to be ok. so do you think my next step is to order...
  11. S

    having to turn the key two or three times

    ok i will have to check into the wires first and then if i have to i will order the starter. does this problem sound like a starter problem to you? or does it sound like a computer problem? thanks for all the help.
  12. S

    having to turn the key two or three times

    hey, i have a 1999 expedition with the 4.6. i live in columbus ga and when the cold came through it my expedition started to act as if it did not want to start on the first turn of the key so i had the battery checked and it was bad. so i replaced the battery and for about three days i had no...
See more

Latest posts

Members online

Total: 4,677 (members: 9, guests: 4,668)

Forum statistics

Threads
57,625
Posts
536,407
Members
54,679
Latest member
Hivolts4u

Share this page

Top