Recently (last several months) my 07 would seem to have the pump going more than usual to maintain ride height. A week ago everything seemed fine till I got in after leaving a store and I got a "check air suspension" warning on the dash and over a few minutes noticed the rear begin to sag. At...
OEM, Raybestos, AC Delco, Hawk, Centric ( last two are lesser known to me.)
Centric and AC Delco are cheapest. Hawk and OEM are most. Not much spread though...$52 at low, about $85 on high end.
Opinions?
Will be using EBC Green stuff pads. Previous rotors were Brake performance...
Ok, my ride has 238,6xx miles on her. Had started missing/hesitating at most all rpms (rough idle, but not in danger of stalling with constant little surges at cruise). Last week I had new plugs installed (Motorcraft), the shop also replaced two COPS on the right bank, front two cylinders.
Ran...
I went from 20" XP alloys to these....
Ford F 150 18"x7 5" Platinum Wheel Rim 2009 14 | eBay
The local roads where incredibly beat up over the winter and the potholes cracked one of my wheels. I went to the 18s to give more wheel protection.
Problem is though, I ordered some shorter lugs...
I tried to replace both rear wheel bearings today and all the hardware came out ok, ABS sensor cable unplugged fine etc... But the bearing would not slide off. The half shaft splines were not stuck in the bearing and were not the issue. It was as if the bearing was corroded to the bracket...
When in 4hi I often get a clunking/jerking sound motion as if teeth on a gear are skipping. Surface was slush and light mud.
During same instance put it in 4lo and it never went into 4lo...tried it again a few min later and same.
As for the clunking/jerking, is it the t-case or are the...
Anyone know for sure? Wanna put poly mounts in and there are many sizes that are VERY close together and I want to get the right size from the get go. If anyone also knows the length of the sway bar links that would be appreciated as well...
I have an 07 EB-EL-4x4 with the tow pack/air ride...
Looking at the kit it seems to be nothing more than spacers for the springs. If the bags just take the place of the springs can the bags sit on the spacers just the same as long as the hoses reach and the sensor can be adjusted?
Thanks guys
Sterling
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.