Search results

  1. F

    Rusted coolant part connected to ECT sensor

    I found the same paet
  2. F

    Rusted coolant part connected to ECT sensor

    i i never found a DIRECT FORD
  3. F

    Throttle warmer

    S my mistake it is a 5.4 ! orasn’t anyone ever seen the 2” high coolant temp sensor wthat rises up from the intake, connects a wwwesmall coolant hose that runs back to the T B ? This coolant sensor riser fitting has a “ J” looking hose connection ( that again connects a small 5/16 coolant...
  4. F

    1998 Intake TB warmer.

    What is the function of this sender ?
  5. F

    1998 Intake TB warmer.

    I have tracked the line that is broken/ rusted off. If anyone has encountered this perhaps you could respond with the proper nomenclature if my description is accurate. The line starts from a coolant junction at the pass side rear of the tb elbow off the intake. This small coolant line...
  6. F

    1998 Intake TB warmer.

    Thanks Yupster, i will take a look see what the condition of mine is. Any time I have done an intake on a Mustang or 4.6 5.4 I automatically just buy one of the intake valley metal hoses. I wouldn’t replace an intake and not do a WP and that bugger metal hose that runs to the rear. Thank...
  7. F

    1998 Intake TB warmer.

    It was only 4 posts, a warm and friendly welcome would have been sufficient.
  8. F

    1998 Intake TB warmer.

    I canceled the general thread and put the question in the correct category. Is that ok ?
  9. F

    Throttle warmer

    Got a 98 4.6 was starting a new intake r/r. Broke off a small hose with a metal fitting down around the base of the Throttle body. It actually rusted. I need to investigate EXACTLY where it goes or its function, but I am guessing a TB warmer. ? Checked YT for manifold replacement, never see...
  10. F

    Running super COLD all the time

    Got a 98. 220 on the clock, runs great but COLD. I man absolutely 99% cold. Idle 20 min heater hose line Slightly warm. I know, check the thermostat, waterpump all the basics, did. Seem to be in working condition. I did notice that the fan makes that roar of rushing air like it is engaged...
  11. F

    Anyone wanna help ?

    No one has a clue ?
  12. F

    1998 Intake TB warmer.

    No one has a clue ?
  13. F

    Replaced thermostat now it overheats

    Isn’t strange how turds like that happen to us all ?
  14. F

    1998 Intake TB warmer.

    Got a 98 4.6 was starting a new intake r/r. Broke off a small hose with a metal fitting down around the base of the Throttle body. It actually rusted. I need to investigate EXACTLY where it goes or its function, but I am guessing a TB warmer. ? Checked YT for manifold replacement...
  15. F

    Anyone wanna help ?

    Got a 98. 220 on the clock, runs great but COLD. I man absolutely 99% cold. Idle 20 min heater hose line Slightly warm. I know, check the thermostat, waterpump all the basics, did. Seem to be in working condition. I did notice that the fan makes that roar of rushing air like it is...
  16. F

    Door lock engagement/ lock / unlock

    Maybe with some simple input I can get this solved. My door locks engage after about 2-3 seconds after in drive. ARE THE LOCKS SUPPOSED TO UNLOCK WHEN PUT INTO PARK? if so what is main responsibility to disengage the locks when put into park ? LooKs like I am going to be here for a...
  17. F

    Recommendation on transferring engine/transmission from 2000 EB to 2002 EB

    Hey ! read your problems with yor expy. I am located in Fort Walton Beach, and interested in your wrecked Expy. Not sure how to make contact, other than a reply from the posting here at the Ford Expedition site. Please reply in some form, we can get together and see what can be worked out...
  18. F

    03 trans clack clack clack noise

    Thanks copper, was what I was looking for.
  19. F

    Transcase Continous Clanking at Low Speeds

    having the same problem, someone here must have a clue, reaal tinny clanking, even on idle, read something about an " anti rattle clip" recall, but dead end.... went under and traced it to the flywheel/converter area. Almost sounds like a loose converter on a flex plate, however checked that...
  20. F

    2003 with a bad flywheel-flexplate

    100 times easier to drop the tranny !! You can still replace all the seals while you are there, save all the fluids, and not put youself through hell out the top..... 2 pennies
  21. F

    Which one to keep ?? 2003 or 2000

    gears Yes, I do tow once in while, pick up a car or a body or something, I guess that is why I like the 3.73's....... I just swapped some stock 265/70/17 for the 16's. Could not really feel any difference, maybe towing I will? Anyhow I agree, condition, condition, condition...
  22. F

    Which one to keep ?? 2003 or 2000

    OP has been back to this thread,,,,,,,,,, Yes I have read all the replies, and I have sent all a thank you for your input. Again, thank you, and what difference does it make if a "OP" returns to a thread?:think:
  23. F

    03 trans clack clack clack noise

    Driving me batty.... I need help on this one, gotta a 03 EB 4x4, around 200 on the clock, I am getting a CLACK CLACK CLAC, tick tic.....isolated right down around the tq converter area... Low RPM mostly when letting off the gas to an idle from 1-3000. Not a motor noise. Read something...
  24. F

    Which one to keep ?? 2003 or 2000

    keeping the 2000 ! end of thread, Now...How do I figure out this new windows 8.1 ?? I thank all of you for your honest replies ! A 18 year ASE tech, Ford specialist...Mustang etc... A newbe to your group, I felt I was welcomed as even a novis new driver,,, Again, thanks.... I knew I...
  25. F

    Which one to keep ?? 2003 or 2000

    I have 2 Expeditions, a 2000 XLT Florida Rust free 4x4, 5.4 3.55s, ( posi)few options, but excellent (I mean new smell ) cloth interior, manual HVAC, super nice exterior in silver, power locks with fob, but , no goodies like the EB's...ie fog lights, no electric vent windows, really tight...

Latest posts

Members online

Total: 2,485 (members: 4, guests: 2,481)

Forum statistics

Threads
57,010
Posts
535,851
Members
54,700
Latest member
RyanStroeder

Share this page

Top