Search results
-
F
HOw do I replace the ABS Control module?
Well I finally have sucesfuly finished replacing my ABS module on my 2004 Eddies Bauer Expedition . The last and final step was to go to my local Ford dealer to have them "calibrate" the replacement ABS module. I was told by the service manger to bring in my old ABS module as the "technician"...- fuzzface
- Post #8
- Forum: How To Section
-
F
HOw do I replace the ABS Control module?
Almost finished Soon I will hopefully finish this job. 1. First you have to remove the air intake system form the air filter back to the fender. 2. To disconnect the wire harness from the ABS module, Lift the locking tab at the bottom and pull up the harness cover. It acts like a lever and...- fuzzface
- Post #7
- Forum: How To Section
-
F
HOw do I replace the ABS Control module?
I still have not been able to "seal" the leaking fitting on the distribution block. I'm afraid if I tighten them any further I'll strip the fitting. Can the fitting be sealed with teflon tape? Is there any other type of sealant that could be used on a brake line fitting?- fuzzface
- Post #5
- Forum: How To Section
-
F
HOw do I replace the ABS Control module?
My Expedition is a 2004 Eddie Bauer with the V-8 engine. Ir does have "Advance Track". Right now my ABS light is on as well as the Brake light. The Advance track button on the center console says is flashing "off". Brakes are working, but may be a little soft. Brake fuild level is fine. I...- fuzzface
- Post #3
- Forum: How To Section
-
F
HOw do I replace the ABS Control module?
I have a brake line that leaked and "drowned" the ABS control module under the distribution block. How do I replace it?- fuzzface
- Thread
- Replies: 9
- Forum: How To Section
