Search results

  1. Calabrio

    Front Wheel Bearings / Hub Assy

    And always be careful with Amazon parts, be very careful of the vendor. Everything isn't sold by Amazon directly. And many of those auto part vendors sell counterfeited and rejected parts. I bought a set of "Motorcraft" ignition coils that all failed within 20k miles. One within just two weeks.
  2. Calabrio

    Air ride to springs/shocks in 1st gen 2001 EB 4x4?

    I think you can replace the rear shocks with anything you like, to the best of my knowledge, Monroe is the one company that sells an EZ install unit that replaces the front airspring. I'd love to be able to try a Bilstein set-up, with the Monroe rear coils, if one existed.
  3. Calabrio

    97 Expy upper control arm question

    I converted the suspension because I had previously owned a Lincoln Mark VIII. I was meticulous about maintaining that system and very active in that car community. Despite this, it would still failing at the most inopportune times. The moment i detected a leak in a coil spring on the...
  4. Calabrio

    1998 Navigator spark plugs

    The flex head socket was the answer. It has to be a relatively low profile, flex socket where the socket and the universal joint are one piece. You don't have room if you try to use an adapter. I spent hours trying to do it without this tool, it took minutes once i had it.
  5. Calabrio

    Blend Door Help

    I don't presume to know the solution here, nor am I likely going to have the answer. But was it working before you replace the blend door actuator? And what part number did you replace it with?
  6. Calabrio

    Brake fluid flush

    Brake fluid technology continues to improve too. Bosch is selling a 5.1 which has a boiling point much, much higher than Dot 3 and 4, and it's not silicon based like DOT5, so you can mix it.
  7. Calabrio

    Rear Heater Core Flush From the Outside

    I need to flush the rear heater core. Can I cut into the two rubber hoses were they go through the floor, flush from there, and they reconnect them with a pair of 5/8 fittings? Doing it that way, would it also enable me to flush out the 18' of heater hose running from the engine to the back...
  8. Calabrio

    98 5.4 coolant level issue!

    I'm inclined to think it was air in the system. How long had it been doing that? Was there any repair or service that had taken place just prior to it? I think these two questions are critical to the internet diagnosis. If the system had never been opened up and it just started doing that...
  9. Calabrio

    Spark Plugs, no more BS

    This is the tool that made all the difference in the world. 7mm flex socket. Something like this: https://www.amazon.com/GearWrench-80253-4-Inch-Drive-Socket/dp/B002YKBL5W With that and some considerable extensions, the plugs went from impossible to merely annoying- without having to remove...
  10. Calabrio

    Air Ride Conversion and Speed Sensitive Steering

    I replaced the air ride system with coil springs on a '98 Navigator. 1- is there anyway, other than physically disabling the light, to disable the 'check air ride light' 2- and does the conversion cause a problem with the speed sensitive steering with the car. I remember having always felt...
  11. Calabrio

    Proactively Replace COP (Coils) ???

    I had about 180k on my '98 with the original set. Everything was seemingly fine. Then, without warning, at least one coil failed. This prompted me to change the set. If you can afford it, and specifically if you have any intention to keep the vehicle, it only makes sense to have them change...
  12. Calabrio

    240K *New Expedtion Owner*

    Not to overwhelm you, but you're getting behind the dashboard to fix a heater core, it is absolutely worth your time to make sure the blend-door actuator is working and healthy before you do. As for the tune up: Use motorcraft parts (they've become remarkably affordable now that you can buy...
  13. Calabrio

    Intermittent Misfire, Line $06 data

    True. And... unrelated... but once I had the 7mm flex socket (not just a wobble extension or a universal joint socket) the plug/coil swap become much less miserable, without even removing the fuel rail. I need to go onto youtube and post that comment on every 'how-to' video I see. Buy the 7mm...
  14. Calabrio

    Intermittent Misfire, Line $06 data

    Increasingly consistent misfire- when it's misfiring, you know. But sometimes, it doesn't. Sometimes at idle. Most likely when under load. Worse when cold. I'd like to disturb as little as possible, so if I can use the OBDII data to provide some focus, I'd prefer to do that. And, I know...
  15. Calabrio

    Intermittent Misfire, Line $06 data

    Has anyone else used any of the non-proprietary obdII scanners on the '98? Were you able to recover the misfire data that should be in $53? I still can't recover anything over $50
  16. Calabrio

    Intermittent Misfire, Line $06 data

    There's the challenge, it's not throwing any code. That's why I was hoping that the mode6 data would provide the information.
  17. Calabrio

    Intermittent Misfire, Line $06 data

    Interesting- I'm using a Bluedriver and the Mode$06 data doesn't include anything over TID50. The support team at BlueDriver are very helpful and responsive, but they don't know why this would be, unless the '98 didn't support the test counting misfires. Does anyone else have any experience...
  18. Calabrio

    Intermittent Misfire, Line $06 data

    1998 Navigator has a misfire that's worse when the engine hasn't been run for a day or it's cold outside. Unfortunately, it's also not throwing any codes. The plugs and wires are all brand new motorcraft parts, no more than four months old. I hooked up my BLUEDRIVER to it hoping to retrieve...
  19. Calabrio

    Spark plugs and compression.

    I just did this over the weekend. I think all of the videos consistently demonstrate that the process is the same on all the cylinder. I suspect that they don't show the "difficult" cylinders because it's hard to film and getting in there takes some trial and error. It is not necessary to...

Latest posts

Members online

Total: 804 (members: 4, guests: 800)

Forum statistics

Threads
53,542
Posts
501,821
Members
47,068
Latest member
hsquared360

Share this page

Top