RIZE lift kit opinions.....

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
D

dairyair302

Full Access Members
Joined
May 28, 2014
Posts
60
Reaction score
1
Location
st.francis mn.
The original owner did my lift. Check junk yards for the parts.

Im on 35-13.5-20 tires but according to them I can fit a 37" tire.

Sent from my SCH-I545 using Tapatalk
 

mindgame

Full Access Members
Joined
Sep 2, 2010
Posts
697
Reaction score
55
Location
Honolulu, Hawaii
Are you running stock setup or coilovers. The reason I am asking is because I have a 06 EB with air suspension and am looking at getting the rize lift and trying to get as much info as I can.

Took me almost 2 weeks to install on my own. Mainly because I had to do this right after work until sunlight was gone.

There is some grinding on the rear portion, other than that, installation is a piece of cake.

Even with the diff plate issue... I have no regrets doing the lift..
:head3:
 
OP
OP
D

dairyair302

Full Access Members
Joined
May 28, 2014
Posts
60
Reaction score
1
Location
st.francis mn.
I got 4.56 gears and the speedo is dead on but idk if thats bc its calibrated.
I will do 37s if my sct x4 can change for tire size...... but these tires are 90% so its gunna be a while.

Sent from my SCH-I545 using Tapatalk
 

Tomringler

Full Access Members
Joined
Jan 21, 2014
Posts
51
Reaction score
4
Location
Hopkinsville, ky
Did you guys have to get a different driveshaft or the brake line kit? Cause I found a site that sells the kit. Here's the link what do you guys think?
 

mindgame

Full Access Members
Joined
Sep 2, 2010
Posts
697
Reaction score
55
Location
Honolulu, Hawaii
Did you guys have to get a different driveshaft or the brake line kit? Cause I found a site that sells the kit. Here's the link what do you guys think?

Yes you will need to install the brake line kit and a new front DS. But this is included in the lift kit.

I went beyond that and installed a double/double cardan rear shaft to minimize the pinion angle even further. Although not required, it was something I wanted to explore.

http://www.expeditionforum.com/picture.php?albumid=204&pictureid=5079
http://www.expeditionforum.com/picture.php?albumid=204&pictureid=5080
http://www.expeditionforum.com/picture.php?albumid=204&pictureid=5081

:head3:
 
Last edited:
Top