Seat belt chime

[boobie33]

Anyone know how to turn off the annoying seat belt chime for a 04 expy?

Sent from my SGH-T999L using Tapatalk

 

[bedrck46]

under the drivers seat is a 2 pin connector from the seat belt clasp disconnect it and place a jumper in the contacts that go to the control module not the connector that comes from the seat belt clasp

 

[bedrck46]

or try this

Safety Belt Minder Deactivating/Activating

Preparation

Before deactivating/activating the belt minder, set the parking brake.
Place gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission).
Place the ignition switch in the OFF position.
Close all the vehicle doors.
Unbuckle the driver safety belt
Place the parklamps/headlamps switch in the OFF position.

Deactivating/Activating

Turn the ignition switch to the RUN position. (Do not start the engine.)
Wait until the safety belt warning lamp turns off (approximately one to two minutes).
NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.

Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation.
Turn the parklamps/headlamps on then off.
Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds.
Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable the belt minder if enabled.
The following sequence of events confirm the belt minder is enabled :
flashing of the safety belt warning belt lamp four times per second for three seconds
three seconds with the safety belt lamp off
flashing the safety belt lamp four times per second for three seconds again
The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled .
After confirmation, the deactivation/activation procedure is complete.

 

[boobie33]

Exactly what I was looking for. Thanks! Ill give it a try

Sent from my SGH-T999L using Tapatalk

 

[bedrck46]

let me know how you make out

 

[boobie33]

Will do

Sent from my SGH-T999L using Tapatalk

 

[DFendersExpy]

or try this

Safety Belt Minder Deactivating/Activating

Preparation

Before deactivating/activating the belt minder, set the parking brake.
Place gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission).
Place the ignition switch in the OFF position.
Close all the vehicle doors.
Unbuckle the driver safety belt
Place the parklamps/headlamps switch in the OFF position.

Deactivating/Activating

Turn the ignition switch to the RUN position. (Do not start the engine.)
Wait until the safety belt warning lamp turns off (approximately one to two minutes).
NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.

Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation.
Turn the parklamps/headlamps on then off.
Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds.
Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable the belt minder if enabled.
The following sequence of events confirm the belt minder is enabled :
flashing of the safety belt warning belt lamp four times per second for three seconds
three seconds with the safety belt lamp off
flashing the safety belt lamp four times per second for three seconds again
The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled .
After confirmation, the deactivation/activation procedure is complete.

And then you do the happy dance....lol

 

[96mustangV6]

Seems like a lot of work to shut off a warning noise lol. Someone was bored when they made that.

 

[ChapPcemkr]

Intermittent Seat Belt Chime

Hello ALL,

Just bought an 03 Expedition XLT. Has 79000 miles on it.

All seems to be good except for the intermittent Seat Belt Chime that just chimes randomly. There does not seem to be a rhyme or reason as to why the chime just comes on. It sometimes ring at highway speed and sometimes at local speeds and others at a stop light. And when it chimes it tend to ring for 3-4 consecutive sets of 7-8 rings.

I'm thinking about doing the disconnection things at the bottom of the driver's seat.

Thanks for your help.

 

[boobie33]

Finally got around to doing it. And it worked. Thanks bedrck46.

Sent from my SGH-T999L using Tapatalk

 

[bedrck46]

Your Welcome