Recent content by IMINYOURCHAIR

  1. I

    Tip for dominating your neighbor

    LOL, OP is just proud of his ride and ppl get butthurt about it. :buffer::buffer::buffer:
  2. I

    97 Expedition XLT: Overheating but heater blow hot air ?!?

    your heater core leak will NOT be inside the truck, it will leak out at the ac condensate drain. I know from experience on this one. http://i.imgur.com/GfUccSO.jpg the core and evap core are right beside each other.
  3. I

    5.4l 4r100 swap into a 4.6 4r70w?

    so the rear arms and whatnot won't swap? I don't know the condition of the rear end of the donor but I think the lsd is either welded or stuck. both tires spin and it binds in hard turns.
  4. I

    5.4l 4r100 swap into a 4.6 4r70w?

    stupid me forgot to keep checking the exposed engine I have in the green machine and it got uncovered slightly and now the exposed bores got water from condensation in them and are rusted pretty bad. I have a 98 expedition here that has frame and body rot but a usable engine and trans although...
  5. I

    Alabama

    I'd love to, but mine's broke down :( 24 mile drive to gadsden for me
  6. I

    How to access to drop the oil pan to change the oil pan gasket on a 1999 expedition 5

    I am having to lift mine up to get the oil pan off for p/u tube and pump replacement while I do the head gaskets. needs to be unbolted from trans though as the bell housing wont clear the firewall unless you straight up pull the whole assy out
  7. I

    Torque converter replacement

    About to lift the engine block off the trans to get the oil pan off to replace the p/u tube and pump. I will be able to get at the torque converter to remove it too because it has the shudder from the front of the truck. same as many of the threads I looked at that ended up replacing it for the...
  8. I

    Rear AC temp vs front temp

    when you added charge to it, did you bleed the air out of the manifold lines first?
  9. I

    Torque converter drain on 4r70w in a 2002 4.6 rwd

    pull the drain cover and confirm which way the engine is supposed to turn and use a rachet on the bolt. or bump the starter via the solenoid to get the drain bolt to line up with the "inspection hole"
  10. I

    New knock sensor broke 97 4.6w

    Okay, I got the first new part to install on the '97 expedition and before it was much more than hand tight the damned thing just cracked. normally I can just blame myself for too much power behind the wrench but there was no resistance. this thing cost near $60 so if I get another I would like...
  11. I

    1997 xlt Looking for a front driver door panel in willow green

    bump
  12. I

    Rear AC temp vs front temp

    rear ac uses expansion valve. front ac uses orifice tube. factory charge is just over 3 lb. I lost my data plate so I charged by pressures with throttle at 2k revs. I can't speak on vent temps I was able to get 34f out of my front vents at best, usually got 42 on really hot days. rear vents were...
  13. I

    1997 4.6 headgasket replacement parts and tools list?

    bump
  14. I

    1997 4.6 headgasket replacement parts and tools list?

    305k miles leaking coolant and oil out of the right rear of the engine. confirmed it was the head gasket. I have the top end of my engine apart with all bolts and all organized. I am ready to order parts but I am not sure what all I need to order. I know I will need a ft lb torque wrench...
  15. I

    1997 xlt Looking for a front driver door panel in willow green

    Looked at multiple yards in my area, can't find one. and I am also having trouble finding a 97-98 4.6 intake.
See more

Latest posts

Members online

Total: 846 (members: 2, guests: 844)

Forum statistics

Threads
53,595
Posts
502,283
Members
47,177
Latest member
hipasia

Share this page

Top