07navi
Full Access Members
Water is hard on those switches, on my Excursion the water from the window washers came right in there if the window was down. I just got this truck so I don't know yet on it.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The auto-up function is what failed on mine (manual up still worked), and the auto-down worked intermittently. When I compared the old switch to the new, the "break" between the manual and auto positions was crisp and positive on the new switch. The old switch felt vague, almost hard to tell the point of transition. Clearly worn out..
I had to replace the driver's door window switch cluster on mine a few months ago because the driver's window suddenly quit going up. Had to pull up rapidly on the swith several times to get it to work.
The new ones might be made differently, mine is vague and I overshoot it a lot.The auto-up function is what failed on mine (manual up still worked), and the auto-down worked intermittently. When I compared the old switch to the new, the "break" between the manual and auto positions was crisp and positive on the new switch. The old switch felt vague, almost hard to tell the point of transition. Clearly worn out.
replace itHello, I just took the door panel off to remove the switch this morning.
My issue is that the drivers window up works less and less. ( down works fine, all other windows work fine) It used to take a couple of goes to make it work. Now it takes a dozen if I am lucky.
So I took the switch out, pulled the covers off and found the contacts which were black as I expected them. I scratched them clean so they were silver again and then sprayed with electrical contact spray. When I put the switch back in place my switch now works about 3/4 of the time, so it's an improvement but not a real fix.
Not sure what my next step is short of replace the switch. Any suggestions? Thanks!
Hello, I just took the door panel off to remove the switch this morning.
My issue is that the drivers window up works less and less. ( down works fine, all other windows work fine) It used to take a couple of goes to make it work. Now it takes a dozen if I am lucky.
So I took the switch out, pulled the covers off and found the contacts which were black as I expected them. I scratched them clean so they were silver again and then sprayed with electrical contact spray. When I put the switch back in place my switch now works about 3/4 of the time, so it's an improvement but not a real fix.
Not sure what my next step is short of replace the switch. Any suggestions? Thanks!