-
-
jr1under replied to the thread Suspicious: shop replaced hub assembly, now says bearings need replacing.Update: 16+ months since this incident, the truck hasn't shown the slightest indication of a problem with the hub/bearings. Reflecting... -
jr1under replied to the thread AC problems.What if it sits outside for a few hours on an overcast day? Just wondering if the problem is the sun or the outside. Have you ever...
-
My ABS module has had a "power failure" code intermittently for a long while. Seasonal in that it was temperature dependent. But I would...
-
No stumbling, just low power and torque.. I would get the PO500 just by cranking it sometimes.. It’s either 3 things, the ABS module...
-
jr1under replied to the thread 2001 Expy new problem.Knowing all you've done to it and how it's been maintained, I'd buy it if I needed another one.
-
UPDATE: Mostly it has just been sitting a couple months. I did replace the following: Purge Valve hose to manifold OEM; Brake booster...
-
We are just a tool they left in the yard.
-
jr1under reacted to Billme's post in the thread Possible to add updated sensors to a Gen 1? with
Like.
Of course, for some reason I wanted to keep it like it came from the factory.. The speed of this PCM would probably cause more problems... -
jr1under replied to the thread Possible to add updated sensors to a Gen 1?.FORScan doesn't support programming Gen1's, mainly because the PCM architecture and datacomm protocol aren't the same as what's been...
-
jr1under replied to the thread PO500 story continues with new twist.Considering all you've done, do you think there's more than one issue? Yours sounds like one of those airplane disaster documentaries...
-
Answered my own question
-
jr1under reacted to Grrumpy's post in the thread Anyone using the Scan Gauge 3 by Linear Logic in a Gen 1 Expedition??? with Like.
Scan Gauge lll sits right in front of you....no looking down/away from road to look at pad or phone for current info......
-
jr1under replied to the thread Anyone using the Scan Gauge 3 by Linear Logic in a Gen 1 Expedition???.If you have an iPhone or iPad and a compatible scanner, FORScan Lite will read those and a lot more. Picture is of some of the...
-
-
jr1under replied to the thread Possible to add updated sensors to a Gen 1?.Just idle speculation...seems that monitoring FRP on a Gen1 would require a pressure sensor on the fuel rail test port with a wired...
-
I had ask this long ago one time, just add a sensor and use a unused pin on the computer to sense what you want.. I’m still looking...
-
-
Loading…
-
Loading…
