-
-
JamaicaJoe replied to the thread P013C CODE CHECK ENGINE 2013 5.4L 3V.I now use FORScan. Still learning the capabilities. -
Just get a real code reader and start there, they are cheap online. No need to go all crazy with the ******** etc.
-
JamaicaJoe replied to the thread 2001 Expy new problem.I would have put it on Bring A Trailer months ago but life got in the way. I need the space.
-
JamaicaJoe reacted to AWAR's post in the thread 2012 6R80 Transmission Service preparation and part confirmation with
Like.
Yes -
JamaicaJoe replied to the thread P013C CODE CHECK ENGINE 2013 5.4L 3V.Well it had a bad o2 sensor and I had all 4 of them replaced and it is running great. Replaced the ABS module with NOS part and the...
-
JamaicaJoe replied to the thread 2001 Expy new problem.Back working on this beast.
-
JamaicaJoe replied to the thread 2001 Expedition 4.6L 2V PCV Valve Questions.My next plan after replacing the brake booster vacuum line is to remove and inspect the plenum duct for cracks in the corrugation. I...
-
JamaicaJoe reacted to AWAR's post in the thread 2001 Expedition 4.6L 2V PCV Valve Questions with Like.
I doubt the pcv is a drivability issue on your Exp. Make sure all the intake air goes through the MAF. I will look for your other posts...
-
JamaicaJoe posted the thread 2001 Expedition 4.6L 2V PCV Valve Questions in 1st Gen Ford Expedition Engine & Performance.I have a 2001 Expedition 4.6L 2V N/A. I have been dealing with driveability problems (see my other posts) that are from a lean...
-
These should be easy fixes, Don't give up on the Expedition yet. Mass air flow sensor is right there on top on the air intake tube easy...
-
My wife felt water in the carpet on the passenger side of our 08Expedition. I thought of resealing windshield until I found out the...
-
JamaicaJoe replied to the thread Looking for detailed door lock linkage diagram (Driver & Rear Passenger) - 2001 Ford Expedition.All those linkages wear out and are easy to repair. I found on my 01, that the 1/4 inch rivets on the rear doors wear out and the...
-
JamaicaJoe replied to the thread High mileage excellwnt condition what to do.I could use some interior trim parts if this is really getting parted out.
-
JamaicaJoe replied to the thread High mileage excellwnt condition what to do.Is it running? Where is it located?
-
JamaicaJoe replied to the thread windsheld washer pump.Probably not, the float gives you a low washer fluid level warning and if it comes on there should still be some reserve. Maybe your...
-
-
Loading…
-
Loading…
