Recent content by FX4FOUR
-
F
Rusted coolant part connected to ECT sensor
I found the same paet- FX4FOUR
- Post #16
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
Rusted coolant part connected to ECT sensor
i i never found a DIRECT FORD- FX4FOUR
- Post #15
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
Throttle warmer
S my mistake it is a 5.4 ! orasn’t anyone ever seen the 2” high coolant temp sensor wthat rises up from the intake, connects a wwwesmall coolant hose that runs back to the T B ? This coolant sensor riser fitting has a “ J” looking hose connection ( that again connects a small 5/16 coolant...- FX4FOUR
- Post #2
- Forum: 1st Gen Ford Expedition General Discussion
-
F
1998 Intake TB warmer.
What is the function of this sender ?- FX4FOUR
- Post #12
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
1998 Intake TB warmer.
I have tracked the line that is broken/ rusted off. If anyone has encountered this perhaps you could respond with the proper nomenclature if my description is accurate. The line starts from a coolant junction at the pass side rear of the tb elbow off the intake. This small coolant line...- FX4FOUR
- Post #10
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
1998 Intake TB warmer.
Thanks Yupster, i will take a look see what the condition of mine is. Any time I have done an intake on a Mustang or 4.6 5.4 I automatically just buy one of the intake valley metal hoses. I wouldn’t replace an intake and not do a WP and that bugger metal hose that runs to the rear. Thank...- FX4FOUR
- Post #8
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
1998 Intake TB warmer.
It was only 4 posts, a warm and friendly welcome would have been sufficient.- FX4FOUR
- Post #5
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
1998 Intake TB warmer.
I canceled the general thread and put the question in the correct category. Is that ok ?- FX4FOUR
- Post #4
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
Throttle warmer
Got a 98 4.6 was starting a new intake r/r. Broke off a small hose with a metal fitting down around the base of the Throttle body. It actually rusted. I need to investigate EXACTLY where it goes or its function, but I am guessing a TB warmer. ? Checked YT for manifold replacement, never see...- FX4FOUR
- Thread
- Replies: 1
- Forum: 1st Gen Ford Expedition General Discussion
-
F
Running super COLD all the time
Got a 98. 220 on the clock, runs great but COLD. I man absolutely 99% cold. Idle 20 min heater hose line Slightly warm. I know, check the thermostat, waterpump all the basics, did. Seem to be in working condition. I did notice that the fan makes that roar of rushing air like it is engaged...- FX4FOUR
- Thread
- Replies: 2
- Forum: 1st Gen Ford Expedition General Discussion
-
F
Anyone wanna help ?
No one has a clue ?- FX4FOUR
- Post #2
- Forum: 1st Gen Ford Expedition General Discussion
-
F
1998 Intake TB warmer.
No one has a clue ?- FX4FOUR
- Post #2
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
Replaced thermostat now it overheats
Isn’t strange how turds like that happen to us all ?- FX4FOUR
- Post #4
- Forum: 2nd Gen Ford Expedition General Discussion
-
F
1998 Intake TB warmer.
Got a 98 4.6 was starting a new intake r/r. Broke off a small hose with a metal fitting down around the base of the Throttle body. It actually rusted. I need to investigate EXACTLY where it goes or its function, but I am guessing a TB warmer. ? Checked YT for manifold replacement...- FX4FOUR
- Thread
- Replies: 13
- Forum: 1st Gen Ford Expedition Engine & Performance
-
F
Anyone wanna help ?
Got a 98. 220 on the clock, runs great but COLD. I man absolutely 99% cold. Idle 20 min heater hose line Slightly warm. I know, check the thermostat, waterpump all the basics, did. Seem to be in working condition. I did notice that the fan makes that roar of rushing air like it is...- FX4FOUR
- Thread
- Replies: 3
- Forum: 1st Gen Ford Expedition General Discussion
