Recent content by joseaguirre

  1. J

    No start after engine install

    I did not, but I’m sure it would’ve given me a fault code. I’m not getting any engine codes and I have 2 injectors unplugged,crank sensor unplugged just to check for power & ground.
  2. J

    No start after engine install

    No I just rechecked it to verify if issue is within pcm. No spark I checked on my scanner data and on one of the parameters it says “ fuel disabled - yes” I checked the coil packs and injectors and I got power but no ground.
  3. J

    No start after engine install

    I just checked voltage on the connector and I have no voltage coming from the pcm.
  4. J

    No start after engine install

    No I installed the timing cover, yes I reset the fuel inertia switch , I also sprayed starter fluid but it just cranks no change.
  5. J

    No start after engine install

    Hi everyone I have a 2014 ford Expy king ranch that dropped a valve and made a hole into a piston. I replaced the engine with a rebuilt one I got everything installed, all grounds are clean & secured. I have no fault codes. Fuel pump comes on(above 60 psi). Spark is good verified with noid...
  6. J

    5.4 nightmare

    Thanks for the help!! Swapped the coil to cylinder #1 and problem followed from cylinder #3 to cylinder #1. Running smooth again.thanks!!
  7. J

    5.4 nightmare

    Appreciate the input will get on it after work
  8. J

    5.4 nightmare

    Hi guys I’m having issues diagnosing this 5.4 2003. I’ve installed a new intake manifold due to being cracked,new Pcv hoses, new spark plugs,cleaned iac valve,cleaned fuel filter,new injector o-rings. It still has a rough idle when in drive or reverse. Fault codes are P2195 & P0135. I performed...
See more

Latest posts

Members online

Total: 893 (members: 6, guests: 887)

Forum statistics

Threads
53,630
Posts
502,576
Members
47,236
Latest member
GeoWebNerd

Share this page

Top