Update
When I turn the key on te 4x4 light does not come on and when I turn the dial on the dash to anything but 2 wheel my auto 4 wheel light comes on
I have 12.6 volts at the fuse an I don't have an open at my 4 wheel selector on the dash
Hi,
So I swapped out my borg warner 4406 transfer case on my 1997 eb expedition and after doing so now my transfer case motor will not shift, I tried re connecting it to my old transfer case and it works as it should but once it's hooked up with the new transfer case it will not shift, I hear a...
So I replaced my transfer case on my 1997 expedition with a 5.4 the transfer case I got was out of a 1998 expedition, now the transfer case motor will not turn I can put the motor on my old t case and it will turn. Now when I try to shift on the dash the 4x4 light won't come on and all I hear is...
So I swapped a 1999 5.4 into my 1997 expedition chassis and after completion of the swap the engine now over revs upon start up it will rev up to 2000 rpm then slowly in steps back its way back down to normal idle just below 1000 rpm so far to try to correct it i have:
replaced all large vacuum...
Hi,
I am in the price of putting a different motor in my 1997 eddie bauer expy. I got a motor off CL but it is out of a 1999 f150 so it has the PI heads. My question is will this new motor work with my old harness and also theres is a sensor on my old lower intake black box and not on on my mew...
Thanks for all your input! well first off I think i will get the glass fixed and look into the price of a gem this weekend when im back home and can use my shop
Any ideas on cost and where to look for a new GEM?.... I really don't want to have to go with motorcraft and pay an arm and a leg
so on one of my trips home I was running my heat and suddenly my dash lights all went dim and also did my radio light, the only thing to stay fully lit up was my high beam indicator and my turn signal arrows, I came to find this only happens when my blower motor is turned on and i also have my...
Alright thanks for the help was hoping it was something like the phaser that could be solved easier than a rod or lifter tick but il just run it and see for now
So I have a 97 expy that I got for dirt cheep and have been spending some cash on repairs after repairing a cracked manifold I came to find that I have a engine knock:facepalm: It sounds like a connecting rod my question is how common is this and also I heard the cam pahsers go is this more...
hi,
So I just got done replacing my front suspension on my 97 eddie and while doing so snapped one of my front flex lines to the calipers
Long story short I replaced the master cylinder both calipers both flex lines and the hard line leading to the ABS block on the drivers side
My braided...
the factory sub in my Mach audio system in my 1997 expy is blown and I am looking to save a little cash (after total suspension rebuild) and just replace the sub to get rid of the anoying rattle
What should I look for as for specs? I was thinking this
Kicker 10C82 Comp Series 8" 2-ohm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.