00 Monster Expedition

craig sargood · May 1, 2020

Installed 6 switch relay system today, along with fixing my blowers and windshield washer pump. Switch works good so far, comes with a sheet of stickers to put on whatever switch you want. Also installed fabtech steering stabilizer, and front camera(apparently those little lights stay on). Also tried messing with my head lights again, I’m pretty sure something is loose in the drivers light( either the projector lens or the metal part inside) not sure what I’m gonna do.

craig sargood · May 1, 2020

Also installed air horn with 1 gallon air tank installed inside passenger side rear fender(where pocket and jack was)

craig sargood · May 1, 2020

Horn is super loud, I’m gonna make a panel to cover pump.

craig sargood · May 1, 2020

Rock lights, Bluetooth, I need extensions for the rear 3 light.

craig sargood · May 24, 2020

Rest of the rock lights and light bars up and working

craig sargood · May 24, 2020

Replaced missing bolt on sway bar today, good as new. Also ran wire into rear door for light that I’m gonna cut into door tomorrow. Was actually able to use washer tube to rear door as sleeve, was easy. I removed rear wiper a while ago. Also finally cut down the inside cap for my wheels, I always hated the way they stood out.

craig sargood · May 25, 2020

Cut led lights into rear door, they run off switch.

craig sargood · Jun 2, 2020

Cut up storage box in back area, and fiberglass the piece and then bed liner that and a few other pieces that needed to be re done. Also started doing some trim on the speaker box and put diamond stitch black suede on the floor. Also found a way to use the old impact struts that came with my lift that were the wrong length. (Fabtech sent the right ones). Fabbed up a bracket to bolt struts to rear side to help hold box from old quad parts. Just waiting for more materials, didn’t measure correctly.

craig sargood · Jun 6, 2020

Finally finishing up the box

craig sargood · Jun 6, 2020

Ran lights around the amps and inside the sub box, need to build a trim panel for amps. Installed 2 cooling fans on top.

00 Monster Expedition

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

craig sargood

Full Access Members

Similar threads

Latest posts

Members online

Forum statistics

Share this page