Search results
-
R
Scan Tool Data
Hi, I have an AncelX6 scan tool. I was checking live data in graph form. Idle air control percent. And, idle air control A. They normally run parallel to each other. Occasionally, the idle air control A moves up and down apart from the opening percentage. Does this mean bad IAC valve? Or, a...- RayBeakley
- Thread
- Replies: 0
- Forum: 1st Gen - 1997 - 2002
-
R
Transfer case motor?
Hi, today driving my 2000 expy 5.4. Driving down highway in rain. I noticed my 4x4 light come on and off. At first it was irregular. But, after a couple of miles became regular. I stopped for gas. And turning out of pumps. Could feel 4wd engaged. I went to dirt lot. Tranfered to 4wd, then 4low...- RayBeakley
- Thread
- Replies: 14
- Forum: 1st Gen - 1997 - 2002
-
R
Weird Re-start
Hi, I have a 2000 ford expy with less than 100,000 miles. Has the 5.4... Runs really well, but just recently. After driving a long distance with the air on. I shut the air off before turning off the vehicle. Let the vehicle sit for a few minutes. Shopping....etc.. I started it, and it...- RayBeakley
- Thread
- Replies: 2
- Forum: 1st Gen - 1997 - 2002
-
R
What transmission
Hi, There has to be an easy way to see what transmission I have. I have a 99 XLT... It has the same gear selector that my 93 Bronco has. ( the little push switch to turn off overdrive ) It feels like it has more shift points. I am just curious as to what I have. What's the best way to check?- RayBeakley
- Thread
- Replies: 10
- Forum: 1st Gen - 1997 - 2002
-
R
Removing exterior door trim insert
Hi, The door trim on my 2000 looks like crap. I saw some 1 and 3/8 inch chrome trim tape. Looks like it would fit where the insert goes. I saw the post on how to remove the whole trim, but what about the insert? I have good paint. If I could remove the inserts, problem would be solved.- RayBeakley
- Thread
- Replies: 8
- Forum: 1st Gen - 1997 - 2002
