Search results

  1. 4

    Truck wont Crank

    Yes i saw the motor spin and the bendix did come out. when i put the ground back on the starter i made sure to clean the ground. no i dont know how to do a voltage drop test.
  2. 4

    Truck wont Crank

    i dont remember what the voltage and resistance was im going to have to check it again to let you know
  3. 4

    Truck wont Crank

    Well, pulled the starter and had it checked. It was good and voltage was good so I'm stumped
  4. 4

    Truck wont Crank

    i will check the power from cable to starter first, i checked the power when cranked on the solenoid and had received power on the starter side but if i get power at starter then im going to give it a go tomorrow and try to pull the starter off and check it. ill bring it to get tested at one of...
  5. 4

    01 Expy - 20 Need Heat

    i had the same problem and my solution was i cut the two heater core hoses and fitted a double male brass adapter to the hoses, porceeded to pour CLR down the pipes with water. Let sit for 5 mins or so and slowly flushed out everything poured water down the used air compresser to blow the junk...
  6. 4

    Truck wont Crank

    Yesterday my 1999 expedition 5.4L quit in the road and was making some weird noises, before it died it started to jump forward then stall a little then do it again. the gauges went dead and the radio cut out. a sound from the bottom of the motor yelled a loud skreech. i proceeded to replace...
  7. 4

    transmission lines leaking

    I have a 1999 ford expedition 5.4l and the cooler lines right above the tie rod are leaking. does anyone know of a diagram so I can get the parts numbers? one of the brackets broke causing the lines to rub on the tire rod as you turn back and forth. tried to fix it but thought best option was to...
  8. 4

    1999 Expy AWD Vibration on medium/hard acceleration

    that's ok, im in it because I like the truck. until the body falls off ill keep it running to the best of my ability (thickness of wallet) haha have had the thing for at least 10 years and haven't had any major repairs so far so we'll so how it goes.
  9. 4

    1999 Expy AWD Vibration on medium/hard acceleration

    so I found out that the vibration/grinding noise is the tranny. one of the clutches in the tranny has gone bad. the front driveshaft would not be the problem as there is no power to it on dry pavement because it is automatic 4 wheel drive not all wheel drive. getting a tranny rebuild soon. that...
  10. 4

    1999-2002 Rusted TRAILING ARMS

    I used a cut off wheel to cut stuck bolts most came off easy. was a little difficult lining up the axle with the arms, I used new bolts as I figured replacing the arms mind as well replace the bolts. make sure to use grade 8 bolts.
  11. 4

    Possible Engine & Tranny ...

    right, I understand its the small stuff that makes it difficult. my 99 has cop for the 5.4L
  12. 4

    1999-2002 Rusted TRAILING ARMS

    no I didn't sadly, I wasn't apart of this forum a month ago. they were very easy tho only spent $40 on metal. when it gets back from the shop ill take a pic of them. Jamison
  13. 4

    Shes stalling on me..

    I will check the line as soon as it gets back from the shop. had it brought to a shop because me and my dad could not figure out what the problem was with the rear blower.
  14. 4

    Possible Engine & Tranny ...

    how bout transplanting an 02 5.4L to a 99 that had a 5.4L? I believe the motor from 99-02 were the same.
  15. 4

    Possible Engine & Tranny ...

    whats the cost for a used 5.4? can you buy a new 5.4? how about buying a 5.4 from a 2002 and put it in your 98? I was looking in doing the same as I have that header leak in the back on the passenger side. what stuff did you buy from autozone to seal the leak? Jamison
  16. 4

    Shes stalling on me..

    my 99 XLT stalls when its cold and I put it in drive and stop but clears up after it gets warm. not sure if its the same problem, almost as if its not getting enough gas. im not very familiar with pvc stuff or the vacuum lines so if anyone can clarify these also that be great. Thanks, Jamison
  17. 4

    P0171, P0174 but engine runs smooth

    my leak was at the engine to manifold. the bolts for the manifold have a tendency to rust then snap off. the codes showed up after I heard the puttering of an exhaust leak, replaced manifold gasket and bolts and went away until I heard the other side start to leak. then a little while later the...
  18. 4

    1999 Expy AWD Vibration on medium/hard acceleration

    I have that same noise when going up hills and the rpm is at 2500 give or take. to me if felt like a universal joint but I wasn't sure. its a vibration/knocking feeling. any help would be appreciated thanks, Jamison
  19. 4

    1999-2002 Rusted TRAILING ARMS

    I made new control arms for my '99 xlt. the way I noticed was when you drove the truck and turned or swerved in the road you could feel the back kind of swaying you might say. just didn't feel tight, almost like the back end wasn't tracking straight. my trailing arms actually had holes in them...
  20. 4

    What did you do to your expedition today?

    spent all day trying to fix rear blower, my side trim I just cut out leaving the gray bar. got whole inside tore apart yesterday and today spent the day with a volt meter testing every connector in the truck.
  21. 4

    Rear blower not working

    ignition power at relay but constant power is not
  22. 4

    Rear blower not working

    Just got a new blower motor and still nothing, no power to motor, power at ac relay. Worked last night after I took down over head console. Very confused, any help?
  23. 4

    P0171, P0174 but engine runs smooth

    I had the same codes and mine I believe is an exhaust manifold leak
  24. 4

    Rear blower not working

    hello, I need help. I took your guy's advice and I replaced the a/c relay and checked all the fuses and switched and the blower is still receiving no power. don't know if blower works or not but I am getting very frustrated. I have a 1999 expedition with the 5.4L thanks for any help, Jamison

Latest posts

Staff online

Members online

Total: 2,387 (members: 19, guests: 2,368)

Forum statistics

Threads
57,011
Posts
535,859
Members
54,703
Latest member
Bluey

Share this page

Top