Search results

  1. martinek

    Air suspension compressor air dryer

    Is it possible, and if so, how, to convert my 1 outlet factory air dryer to my replacement air dryer with 2 outlets?
  2. martinek

    High performance intake manifold needed

    I have a 1998 Expedition, 4X4, Eddie Bauer, 5.4L. I blew my intake gasket and since I need to change it, I'm looking for a high performance, preferably chrome, intake manifold, upper and lower, gaskets and mounting hardware kit. Does anybody have any suggestions of where to find exactly that...
  3. martinek

    PO171, PO174 engine codes

    I keep getting the PO171 and occasionally the PO174 codes. I have replaced my PCV valve and ALL the lines, including the 90 degree boot on the back of the engine. I have put clamps on all the connections. I used starting fluid to spray when it runs rough and it keeps coming back to the little...
  4. martinek

    AC Not Cold, Heat not hot

    I have a 1998 Expedition, Eddie Bauer, 4X4, 5.4L Triton. My AC is not cold. It is blowing cooler than outside air but not cold. My Freon is in the good mark, not low, not high. My compressor is kicking in and working fine. Also, when I put on the heat it blows warm but not hot. What could...
  5. martinek

    Overhead console removal

    How do you remove the overhead console on a 1998 Eddie Bauer Expedition? I need to replace my heater control lights. It will not light up at night.
  6. martinek

    Las Vegas with an Expedition challenge

    I have a 1998 Expedition. The cruise worked this morning but did not this afternoon. I have no "on dash" cruise light, never did. The connector on the master cylinder has the recall jumper harness on it with the fuseable link inside. There is brake fluid inside the switch connector. My volt...

Latest posts

Staff online

Members online

Total: 1,534 (members: 27, guests: 1,507)

Forum statistics

Threads
53,614
Posts
502,473
Members
47,212
Latest member
okiman

Share this page

Top