Baja Forged Rear Bumper Guard

[KFordEx8]

Anyone have this installed?

https://www.bajaforged.com/product-page/baja-forged-2022-2018-ford-expedition-rear-bumper-guard?

It looks like hitch pin and trailer wiring connector are blocked or may be difficult to access so I’m wondering about that.

Also, pricey.

 

[AKDV]

That's interesting...I too would like to know if it hinders trailer usage.

 

[JAMADOR]

Looks good, IMO.
Curious about how it's installed/attached. Doubt my wife would go for it, though.

 

[DSF1]

Also looks like those tires will rip the front fenders off when they straighten them out again. I run 35s on my 3rd gen (which has a couple inches of suspension lift) and I had to recip the front of the running boards, use a heat gun to re-form the bumper skirt and wheel liners, and they STILL RUB! Looking at the clearance of the rear wheels -which is MUCH tighter than mine, I dont see how they could drive the truck with these tires!