TactialMonkey
Full Access Members
I put LED front indicators in and the blinkers are going crazy and yes I put a resistor on all 4 lights but I am wondering why its still doing this
Blinker is really fast!
- Thread starter TactialMonkey
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
stamp11127
Full Access Members
What resistor value, how is it wired?
If there wasn't any change in the flash rate, one of two things may have happened.
First, poor connections if you used those crimp splice taps. They are there physically but not connected to the circuit.
Second, resistors aren't enough to load the circuit and slow the flash rate.
If there wasn't any change in the flash rate, one of two things may have happened.
First, poor connections if you used those crimp splice taps. They are there physically but not connected to the circuit.
Second, resistors aren't enough to load the circuit and slow the flash rate.
Last edited:
tonydiv
technical advisor
Just get a 'zero load' flasher from a place like superbriteleds.com.
It's the correct way to run led signal bulbs.
It's the correct way to run led signal bulbs.
OP
OP
TactialMonkey
Full Access Members
I'll try the flasher. Where is it located because when I had the dash off there was tons of friggen relays
GAINMOB
Full Access Members
I have led switchbacks turn signals...led tails...led in my mirrors and had the hyperflash...bought a LED flasher relay and solved the problem...I created a thread...hyperflash turn signals and someone gave a link to me and I bought it...problem solved...thats all u need...no resistors or anything to wire...they even put pics of where its located
Holy Rollerz Christian Car Club (HRC3)
Holy Rollerz Christian Car Club (HRC3)
Similar threads
