Do you know what is the problem with these displayed codes?

[ahammed akkif]

 

[ahammed akkif]

Do you know where the driver glass position sensor is located?

 

[Benztech]

The glass position sensor is probably in the window motor. Does the express up and down work? If so I wouldn't worry about the code. The SRS code could be a number of things but I'm guessing a clock spring since it's the driver front. I've seen similar codes before when I was a tech.

 

[Mr Big]

What does the malfunction indicator lamp look like?
There is a recall for safety belt tensioners that can explode. What year is your Expedition.

 

[ahammed akkif]

2018

 

[ahammed akkif]

The glass position sensor is probably in the window motor. Does the express up and down work? If so I wouldn't worry about the code. The SRS code could be a number of things but I'm guessing a clock spring since it's the driver front. I've seen similar codes before when I was a tech.

Each time the town is pressed, it rises and falls an inch at a time

 

[Mr Big]

2018

Here is the recall notice. I don't know if it applies to you or not, but worth looking into.

 

[ahammed akkif]

Each time the town is pressed, it rises and falls an inch at a time

Each time the town is pressed, it rises and falls an inch at a time

That means if i want to Close the glass once, press the button at least 10 times

 

[Mr Big]

If you are referring to your windows, follow the instructions to reset them.

1. Close the window.
2. Press and hold the window control switch until the window is fully open. Keep the switch pressed for a few seconds.
3. Lift and hold the switch until the window is fully closed. Keep the switch held for a few seconds.
4. Press and hold the switch until the window is fully open. Keep the switch pressed for a few seconds.
5. Lift and hold the switch until the window is fully closed. Keep the switch held for a few seconds.

Note: Repeat the procedure if the window does not close when you use one-touch.

 

[ahammed akkif]

Front Window Position Sensor issue solved
I replaced the motor and solved the problem

B0002 - Driver Frontal Stage 2 Deployment Control pending....

 

[ahammed akkif]

What does the malfunction indicator lamp look like?
There is a recall for safety belt tensioners that can explode. What year is your Expedition.

driver airbag light on

 

[ahammed akkif]

: B0002 - Driver Frontal Stage 2 Deployment Control


Additional Fault Symptom 13):
- Circuit Open


Status (-8B):
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC


Module: Restraint Control Module

 

[Mr Big]

driver airbag light on

You need to contact your dealer. I had the same thing twice, once for each side. The pretensioner safety switch is shorted and will eventually explode in the vehicle, making a very loud shotgun sound. The seatbelt will be stuck and not be able to use once retracted. If your vehicle meets the recall it is a free repair. I would not hesitate, as once the fault message appears, it is only a matter of time when it blows.
I'm not trying to scare you, but it full blown happened to me and it is scary, to the point, if you are driving, you could lose control.