run time

[BakerEdition]

O.K. I got most of the programming figured out with this Edge CS programmer...I just ran a 0-60 in 10.2 seconds....I didn't think that was bad for a 7000lbs truck?? thoughts? Still working on the shift points....I was curious though...the electronic coolant temp shows that this heats up 188 degree and stays there unless im really driven it hard then will go to 192....I thought these were to heat up to 192 and level off? thoughts..

 

[panda24619]

this is my fastest time. it was at night and my engine was cold. if i try to do it when shes warmed up i think its like 11 something.

 

[SOLISIMO]

Shocking! Panda was the first to respond to a 0-60mph post

 

[99 Expy]

Couldn't say what mine is other than SLOW!!! I think my little 4.6 ran 12 or something if I remember counting it right, but that was in Iowa. Now that I'm at 7200 ft in Laramie, the elevation makes it even worse. Although I can get going pretty quick coming down the summit on the east side of town... I will hopefully get back with some better numbers when I get around to my rebuild next year ...

 

[BakerEdition]

Hey leave panda alone..LOL...I was the first run I did since I put the programmer in...still working on the right programming...with WOT and the Rev limiter...

 

[toms89]

I need to borrow someones Edge to check mine. My sct does not have this function. I think its available as a add on.

I can tell you mine ran 8.9 seconds in the 8th mi @ 78 mph so I think it is in the 6 second zone to 60mph. Hope to improve that dramatically here soon.

 

[walnuts4x4]

See edge is better than SCT.......

I'll have to go double check my numbers... but my coolant usually stays around 198-200...

 

[tallsville]

all depends on witch programmer he has. not all of them have the screens so you can see.

 

[BakerEdition]

I posted this in another thread I believe

EDGE 8 gauge lay out This is part # 85150 also has the chritmas tree for 1/4 mile run and a screen for 0-60..I will shoot some video...

 

[toms89]

See edge is better than SCT.......

I'll have to go double check my numbers... but my coolant usually stays around 198-200...

lol... I like the look of the edge better but I had to have the sct for the custom programming. SCT does have a touch screen version with the same type of features as the edge but it was too much $$ for me.

http://www.sctflash.com/products.php?PID=10&VID=

 

[tallsville]

thats the one i want. but its $1100 with custom tunes tuned on a dyno. or $800 by itself at least in LA. not sure what it is elsewhere.

 

[BakerEdition]

touch screen

I seen the touch screen and my fingers are to fat and my luck just something else to go wrong...I will stick with the buttons..however I do like the size of the touch screen being larger...however would have had a problem mounting it in the overhead console...

 

[tallsville]

ok just got my new toy thanks expydrew. So i went to the mountain ridge road (where i made my exhuast vids) and did some 0-60's. here are the results it was about a 15-20 mile to the spot so engine is warm and air temp was about 81. And probably at 2500+ foot elevation.

Stock set up
2wd 9.30
4wd 9.83

87 tune
2wd 8.43
4wd 8.76

Not to bad what do you guys think?

 

[toms89]

ok just got my new toy thanks expydrew. So i went to the mountain ridge road (where i made my exhuast vids) and did some 0-60's. here are the results it was about a 15-20 mile to the spot so engine is warm and air temp was about 81. And probably at 2500+ foot elevation.

Stock set up
2wd 9.30
4wd 9.83

87 tune
2wd 8.43
4wd 8.76

Not to bad what do you guys think?

Down hill?? lol

I have never seen a sub 9 second 0-60 4wd 1st gen "stock" expy posted. (Doesnt mean there are not any) So yeah I would say thats good.

 

[tallsville]

tom mine is a 2nd gen. road not flat up and down but fairly flat. you can watch my exhaust vid to see the terrain. need to find a flat road around here with no police. And im not stock got a k&n fipk and a cat back exhaust DI/SO

 

[panda24619]

yeah good luck talls. haha remind me not to race you.

 

[toms89]

tom mine is a 2nd gen. road not flat up and down but fairly flat. you can watch my exhaust vid to see the terrain. need to find a flat road around here with no police.

I should have said 2v 5.4. If you check both directions in the same spot it should average out the effect of the terrain.

 

[tallsville]

kinda hard i started just after a sharp turn. not sure expy could make that turn at 60. might be fun to try though. i'll make sure i take and extra pair of underwear.

 

[toms89]

Yeah...lol might not want to try that then.

 

[toms89]

I went to the following site and punched in my timeslip numbers just to see what it would say my 0-60 would be (estimated) on my expy.

http://www.wallaceracing.com/0-60_equation.php

For my expy with 8.806 1/8 mi @ 79.44 it came up with 5.02 seconds.
For my stang with 6.646 1/8 mi @ 104.45 it came up with 2.19 seconds 0-60mph.