Memory power seat install into XLT/SSV - which wires to tap on second harness?

ebasista said:

White connector C312 . Green/red stripe needs 12 v constant power and it works

Click to expand...

ebasista said:

It's a 30A fuse typically. That said if you only run one motor at a time it pulls 4A or so.

The black connector that the SSV has and the seat also has is called C311 and may have a grey/red wire on it. This would go hot to a 30A fuse in the battery junction box.

I didn't splice to this but ran a separate power feed to my new center console and went from there since the pass seat had no power originally.

Click to expand...

penseb said:

I'm not finished running all of the individual switch wires to the motor wires (bypassing the memory switches and the driver seat module) but I have 4 out of 8 connected. Power is running into the green/red wire in the white c- 312 #11 connector location; ground is running into the solid black wire in the black c 311 #14 connector location. And I have lift off!!! (In the driver seat module unplug plug #A [black/violet and grey/red wires); All of the motor wires are found in plug #B; all but one of the switch wires are found in plug #C; and the 8th switch wire, position #8 Violet/brown is found in plug #D... Plug E is also ignored). Message me if you have questions.

Sent from my LG-H918 using Tapatalk

Click to expand...