Search results
-
2
2wd expedition on ice
My dad drives a 2005 2wd drive expedition in the michigan winter. Its not the snow that will get you its ice. You have no control on ice with 4x4 or 2wd. You would be fine with a 2wd put 200 pounds of weight in the back and don't be stupid.- 2001Expy
- Post #4
- Forum: General Discussion
-
2
Temp gauge not reaching normal point....
It has heat but probably not as much as it should. I should probably replace it anyways, I have 177xxx on the clock and its never been done. It looks easy from what I have read online. Thanks for the help. I will report back if it worked or not. Calvin- 2001Expy
- Post #5
- Forum: 1st Gen - 1997 - 2002
-
2
Temp gauge not reaching normal point....
I have a 2001 5.4L expy. As the weather has gotten colder, I noticed the temp gauge is only reaching 1/4 of the way up the range. When usually it reaches 1/2 of the way. This is after driving 20 minutes, there is still heat and all the fluids look good. Could it be a sensor? Thanks, Calvin- 2001Expy
- Thread
- Replies: 5
- Forum: 1st Gen - 1997 - 2002
-
2
anyone has a design for a welded kayak carrier to fit into trailer hitch
As a kayaker myself, I see height being a problem if you are holding it vertically on your hitch. They make holders that have rollers on the back and just lift the tip up there and then slide it on. (you can use a welcome carpet to protect the paint) -
2
Bent Running board
I'm going to try and jack it up and use the weight of the truck to bend it back. -
2
Bent Running board
jstrut: I have the xlt version so it is the tube running boards. Thanks for the input though, I'm located in GR. Jay: It is bent Downwards, a tire went up on the running board and forced it down. I think I am going to try to bend it back up and if it works great, if not I'm taking them off. -
2
Bent Running board
The drivers side running board is bent down. From a accident:gr_guns: that happened a while back. I am looking to try and bend it back, anyone ever try this? I will get pictures later. -
2
Creaking While Turning and Driving
Hey Everyone, I have been having a creak when I turn the wheel and every time I hit a pothole or bump. I believe it's the ball joint since they are original with 166K on the clock. Is there anyway to test and see if its the ball joint or what other part it may be? It is only on the drivers...- 2001Expy
- Thread
- Replies: 2
- Forum: 1st Gen - 1997 - 2002
-
2
Passenger window off track???
Hello Everyone, Last night my passenger window fell down as I was putting it down, It tilted forward and then fell into the door. I have removed the door panel and made sure everything was intact. I have found the the linkage between the inside handle was stuck in one of the clips that hold...- 2001Expy
- Thread
- Replies: 2
- Forum: 1st Gen - 1997 - 2002
-
2
Leaking Differential ??
I have a leaking differential and am wondering since its a lifetime seal if I could take it to ford and have them fix it or am I sol and fixing myself. Its an 01 with 160xxx Thanks Calvin- 2001Expy
- Thread
- Replies: 17
- Forum: 1st Gen - 1997 - 2002
-
2
anyone safely mount a kayak on a safari roof rack on an Expi?
I have mounted 2 kayaks on top to my expy. My dad made a homemade rack out of 2*4 and I believe it just straps to the cross bars and then the kayaks on to that with bungee cords and ropes running to the front tow hooks and to the trailer hitch. Didn't go anywhere at 70mph. I'll try to get them...- 2001Expy
- Post #6
- Forum: 1st Gen - 1997 - 2002
-
2
4 Wheel Air To standard suspension conversion
I got the same kit and there is no top or bottom on those springs. Maybe I installed them the wrong way but I haven't had any problems with the ride or anything.- 2001Expy
- Post #4
- Forum: Suspension
-
2
idling issue driving me nuts!!! help!!!
It could be a miss starting. From the COP's, which makes it idle a little funny. It won't throw a code until its truely missing.- 2001Expy
- Post #2
- Forum: 1st Gen - 1997 - 2002
-
2
Need air to coil conversion advice please.
I got my conversion kit from rockauto.com for $200.00 + shipping. It has the same ride height as before maybe sits a little lower. I would get new because you may end up with bad coils.- 2001Expy
- Post #3
- Forum: 1st Gen - 1997 - 2002
-
2
Air or Conversion?
I recently switched from air to coil and I wish I stayed with the air. Only because I tow a lot, I should drive a Super Duty for how much I do. The ride is great with the coils but it sags with a load on the hitch or in the back.- 2001Expy
- Post #12
- Forum: Suspension
-
2
What do you have done...in the inside?
I would like to see pictures of the bed lined cargo areas. -
2
Tips for Preparing to Offroad!
Panda, I assuming that you mounted it on the roof rack cross bar. I might have to play with that idea, I already made a bracket for the the tow hook. Talls I already have a paper filter. With the votes of confidence, I might have to try a little more than just being the people hauler. Just...- 2001Expy
- Post #8
- Forum: General Discussion
-
2
Tips for Preparing to Offroad!
I have the ORV flag and need to buy the sticker for the year. I have a air compressor/jumper box for airing back up. I was just wondering about maintenance because my dad was talking about sand getting in the engine and breaks and everything and messing something up. We are planing on...- 2001Expy
- Post #4
- Forum: General Discussion
-
2
Tips for Preparing to Offroad!
Hello all, I am preparing to go to silver lake sand dunes. I not going to do anything crazy just pretty much drive to the beach area and use the expedition as a home base for the day. Is there any tips for maintenance and anything else in general that I would need to know. Right now...- 2001Expy
- Thread
- Replies: 10
- Forum: General Discussion
-
2
Air to Coil Conversion Kit F/S
It would be about $50 for ground, I'll split the cost with you. You can Pm me for my phone number if you would like to discuss it more.
