Not sure if any of you Eddie Bauer guys have every done this before, but since I am planning on painting my Eddie Bauer fender trim BLACK, my tan pin stripe will be the only tan thing left on the truck... therefore I'll need to remove it!
Any suggestions on how to remove it without destroying my paint? I also am scared of being able to see where the pin stripe was before...
This is the best tool I could find for the job:
http://www.amazon.com/Stripe-Off-Wheel-07498-Hardware/dp/B00063VT0G
Also, think I might be going with a spray on bed-liner rather than plasti-dip. Either that or some other type of "exterior" spray paint.
Any suggestions on how to remove it without destroying my paint? I also am scared of being able to see where the pin stripe was before...
This is the best tool I could find for the job:
http://www.amazon.com/Stripe-Off-Wheel-07498-Hardware/dp/B00063VT0G
Also, think I might be going with a spray on bed-liner rather than plasti-dip. Either that or some other type of "exterior" spray paint.