Yep I had a spray wax dry on that part on mine with pretty much the same results as yours.
Turned white and would not wash off.
I just buffed it off with some polishing compound.
Like was said they are "dummy" gauges.
They've been like that on Ford models for the past 15 years or better.
Apparently people get worried when they see a real pressure guage fluctuating.
Sorry I didn't see this, I haven't been on here in a few weeks.
I've taken mine off to have a piece painted and its not too bad.
Start by removing the 5.5mm bolts in the wheel liner and the few that are under the front bumper, then fold the liner back.
This allows you to look where the...
Oh I wasn't following at first.
So you're getting that Ebay seller to paint you some emblems? They don't include the cover for the washer with it?
I always just assumed they would since it all comes with the emblem when they buy it to paint it.
If anything I'd pop the center cap off the factory wheel while mounted and just take a few measurements.
I do know that some factory takeoffs will fit with the center caps. Like those ones you posted, I don't see why those wouldn't work.
It's no big deal to trim the ends of the axle shafts.
Took me less than a minute on each side with a cutoff wheel, but if you're not doing it yourself im sure whatever tire shop you take it to can do it if you ask.
Mine has the camera too, it's a platinum, but I don't think that matters.
After i took the radiator cover thing off I managed to squeeze my hand in front of this radiator just to like my wrist.
At just the right angle with a light through the area where the hood latch is you can see the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.