abs
-
R
New brake line flares won't seal at ABS Pump ports
Hi all. Had an issue with my front passenger brake line blowing out on one of the angled portions after the braided hose part, right where there's a rubber insulating elbow that apparently got water trapped under it. Had enough brake pressure to get home, had it towed to my shop so I could work...- rwc265
- Thread
- 2009 abs abs pump brakes expedition
- Replies: 3
- Forum: 3rd Gen Ford Expedition Wheels, Tires & Brakes
-
2011 XLT - ABS issues - Check Brakes - Service Advance Trac - Code B1342
On my 2011 XLT 2WD I face the issue that even after having the ABS control unit (electronic black box bolted to the ABS pump) checked and refurbisched by a professional company, the Code B1342 comes back immediately after reset with the diagonosis tool/reader. When I sent the electronic black...- AndyExpy3rd
- Thread
- abs abs controller abs module advancetrac brake controller stability control traction control
- Replies: 10
- Forum: 3rd Gen Ford Expedition General Discussion
-
D
Need Advice on ABS Pump/Module on 2007 2WD Expedition
Hello everyone! Looking for your expertise! I have a 2007 Expedition XLT 2WD with 300,000 miles and it's a daily driver! We have an issue with the ABS Pump/Module. The ABS is activating every time we apply the brakes - even lightly. The ABS light is on. Used Forscan software to read codes...- dc5942
- Thread
- 2007 ford expedition xlt abs abs controller abs module abs pump expedition
- Replies: 4
- Forum: 3rd Gen Ford Expedition Wheels, Tires & Brakes
-
Z
07 Expy Advanced Track Steering Shake on Bumps
Have a 07 expy eddie w/ the advanced trac system. 165k miles. It does have a leveling kit with bigger 285/70/r17 tires on factory wheels Through troubleshooting another issue, I reset the ECM by draining the capacitors and doing a re-learn. The steering wheel has always shaked a little when...- Zigwaldo
- Thread
- abs advancetrac ford expedition 2007 steering angle sensor steering wheel shake
- Replies: 0
- Forum: 3rd Gen Ford Expedition General Discussion
-
M
Looking for Pinout for abs module connector to diagnose abs light
I'm looking in the Ford Service Manual and it says Disconnect: Anti-Lock Brake Control Module C135. z Key in ON position. z Measure the voltage between anti-lock brake control module C135 pins, harness and ground as follows: z Are the voltages greater than 10 volts? Pin Circuit 1 534...- MapleTSyrup
- Thread
- abs c135 stability assist
- Replies: 4
- Forum: 2nd Gen Ford Expedition Wheels, Tires & Brakes
-
help! plz
Hello and good day my advancetrac is showing an error and my scan tool shows, steering angle 1 can move from low to high but steering angle 2 is always hi voltage. my abs trac contrl lights are on all the time with no abs and winter is coming, is it my sensor that's fried or wiring most info...- Kyle22
- Thread
- abs advancetrac help sas steering steering angle sensor
- Replies: 3
- Forum: 2nd Gen Ford Expedition General Discussion
-
J
2012 Expedition XLT EL "Service AdvanceTrac" and ABS lights on
I have a 2012 Expedition XLT EL. The other day the "Service Advancetrac" warning appeared on the instrument panel readout and the ABS lights came on also. Then, for a brief second, I lost brakes. Then, the brakes started working again, but the lights stayed on. Later, after having been parked...- Jermy-Jinky
- Thread
- 2012 abs advancetrac brakes expedition xlt
- Replies: 0
- Forum: 3rd Gen Ford Expedition Wheels, Tires & Brakes
-
H
ABS Codes: C1165, C1235, B1676
2007 EL 357K ABS light came on. Scanner came back with the following codes: C1165: Right Rear Wheel Speed Sensor Input Circuit Failure C1235: Right Rear Wheel Speed Sensor Input Signal Missing B1676: Battery Pack Voltage Out Of Range Before I take it into the shop, wanted to see if anyone...- Hoos95
- Thread
- abs b1676 c1165 c1235 codes
- Replies: 2
- Forum: 3rd Gen Ford Expedition Wheels, Tires & Brakes
