1998 Factory Amplifier Location

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

socomboy

Full Access Members
Joined
Dec 16, 2009
Posts
53
Reaction score
0
Location
Memphis, TN
Hello board! This is my first post so hear we go.....I know about the '97 amplifier thread but it did not provide an answer so does anybody know where the factory amplifier is in the PREMIUM (not MACH) sound system in a 1998 Eddie Bauer Expy?

Thanks Guys!
 
OP
OP
S

socomboy

Full Access Members
Joined
Dec 16, 2009
Posts
53
Reaction score
0
Location
Memphis, TN
I want to bypass the factory amp for my aftermarket stereo. I have all the necessay harneses but can't find the amplifier.
 

grizfyrfyter

Member
Joined
Dec 30, 2009
Posts
10
Reaction score
0
Location
Sonora, CA
i believe it on the right side near the 3rd row seat. i havent seen it (it was bypassed when i got the car) but i read about it somewhere. could be the newer models though. good luck.
 

lakmflx

Full Access Members
Joined
Jan 5, 2005
Posts
485
Reaction score
2
Location
P.C.B
The factory amp is located on the rear passenger side of the truck where the 3rd row seat is. Easiest way to find it is look for the jack compartment. Once you find that then that whole plastic piece needs to come off so you can gain access to the amp.
 

aaronl

New Member
Joined
Feb 21, 2010
Posts
2
Reaction score
0
Location
Texas
I just replaced the factory unit in my '98 w/premium stereo. The amp is in the dash, you can see it when the radio is removed, it's sort of behind & below the climate controls. The harness you need to bypass plugs in at the bottom, which if you look under the dash towards the middle near the console you can see the bottom of the amp & the plugs. The amp in the rear is for a sub in the Mach system.
 

EXP Edition

Active Member
Joined
Feb 25, 2010
Posts
25
Reaction score
0
Location
Rochester Minnesota
All I did to bypass mine was the same thing I did in my Durango with the Infinity speakers..

Take your remote wire turn on from the deck and connect it to the blue wire coming from the dash. I believe it is the power antenna wire coming from the dash. That's it! My speakers all turn on fine!
 

henry98

Member
Joined
Nov 20, 2009
Posts
22
Reaction score
0
Location
niceville
I want to bypass the factory amp for my aftermarket stereo. I have all the necessay harneses but can't find the amplifier.

its behind the radio straight down..its a bear to remove i just removed mine and by passed it even though it worked perfectly fine
 
Top