Anyone install a Readylift leveling kit?

[WVgirl]

Yes I am. I have 1.5" spacers. They are not needed I just wanted the look. I do have very slight rubbing on the front but nothing bad at all.
View attachment 33745
View attachment 33746

Sorry. I didn’t see those were factory wheels. So you just used spacers to bring them out some. I love the look it gave yours.

 

[757expedition]

Very light trimming of the inner fender liner. I have the retractable running boards. I did shorten them about 3 inches. Simple to do.


Sent from my iPhone using Tapatalk

Can you share some pictures of the trimmed auto running boards as well as the process?

 

[fordguyca]

Hello All,

I have a 2020 Expedition Max and am currently having the 3/2 kit installed on it. My question is, does anyone think I’d have any issues with rubbing or having to trim with BFG ko2 285/65/20? Rims are stock from the factory, so I’m assuming they’re a pretty positive offset.

 

[sanman28]

Hello All,

I have a 2020 Expedition Max and am currently having the 3/2 kit installed on it. My question is, does anyone think I’d have any issues with rubbing or having to trim with BFG ko2 285/65/20? Rims are stock from the factory, so I’m assuming they’re a pretty positive offset.

You will be fine.

 

[Zero Offset]

I cut 2” off and trimmed a little of the fender. The end cap is held on by two small screws. Once you cut the step you will have to drill new holes or use self tappers.
View attachment 65585


Sent from my iPhone using Tapatalk

Is this a job for an angle grinder or reciprocating saw?

 

[Hokieskins]

Enjoying the thread

 

[Wes1]

ReadyLift on my 2022 XLT with factory wheels and 295's. Small trim to rear liners and rub a little on front. However I have only had it 2 days so need to check it out a little closer.